Models > DG101 > Instructions

DG101 Maytag Dryer - Instructions

All Instructions for the DG101
31 - 35 of 35
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Installed wheel assemblies to rack
Assemblies snap on, no tools needed
Parts Used:
Lower Dishrack Kit
  • Philip from Greene, ME
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Leg was mssing after move into new home.
Purchased x4 new adjustable legs. Leaned the washer back and held in place with block of wood. Loosened the two older front legs with an adjustable wrench because they had a locking nut and replaced with new legs. Repeated process on back side of washer. Once all the new legs were installed leveled the machine adjusting the legs if necessary.
Parts Used:
Adjustable Leveling Leg
  • Matthew from The Woodlands, TX
  • Difficulty Level:
    Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
rumbling noise
Remove dryer back,release spring tension to remove belts. Clean lint and pulleys. Replace belts,spring tension and back and LEVEL Dryer. NOTE: The back is part of the frame, make sure all screws tighten DO NOT omit any.
Parts Used:
Dryer Motor Belt DRIVE BELT Drum Roller Shaft Washer
  • John from Follansbee, WV
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Pliers
Was this instruction helpful to you?
Thank you for voting!
Lint screen had holes
New lint screen
Parts Used:
Lint Filter
  • Mary from Cudahy, WI
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Replaced both belts.
Bought a house and inherited an ancient set of appliances. I figured that they dont make em like they use to so why get rid of them. Noticed the dryer tub wasnt spinning one day after running through three cycles. I took the back off and realized the belt that made the tub spin was broke. Went ahead and ordered both belts (old age catches us all) so i wouldnt have to order the other a few weeks later. Pulled the spring took the old belt off put on the new ones like ya would a bike chain. Used the pliers to put the spring back on and voila.
Parts Used:
Dryer Motor Belt DRIVE BELT
  • Dane from Brookeland, TX
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Socket set
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the DG101
31 - 35 of 35
Back to Top