All Installation Instructions for Samsung Refrigerator DFSS9VKBASS

Refrigerator was too cold - down to 18 degrees Fahrenheit.

Removed shelves. Removed back cover. Removed old sensor. Installed new sensor. Replaced back cover. Replaced shelves. Works fine.

Parts Used:

Temperature Sensor

Bill from RALEIGH, NC
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

5 of 14 people found this instruction helpful.

Was this instruction helpful to you?

Spring replacement on Mullion Door

had to replace the spring on the Mullion door . the how to video helped however the demonstration shows putting the spring on in the opposite way that my door calls for, so just I turned the spring around and done, other than that easy as pie.
thanks
Chris F.

Parts Used:

Spring PIN - French

Chris from YORK, SC
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Spring broke on the side by side door.

Very carefully used the pliers to put the spring in the two slots with the door mullion. Works like brand new

Parts Used:

Spring PIN - French

Door Mullion Spring

Jerry from Danville, IA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

1 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Brokjen spring

Lifted out the broken part and replaced with new spring.

Parts Used:

Door Mullion Spring

Sharol from Culdesac, ID
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

french spring broke

after receiving spring installed spring in seconds. Thanks partselect.com Ryan Cappell

Parts Used:

Door Mullion Spring

RYAN from RIVERBANK, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

We misplaced the mounting screws for our handles while moving.

It was easy! I just used an alan wrench to losen the side bolt, then slid the handle into the new mounting screws that I had hand-screwed and then tightened it all up.

Parts Used: