My Orders
DF260760 (23) Gaggenau Dishwasher - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Chronic water leakage
2 of 3 people
found this instruction helpful.
-
Callan from CHICAGO, IL
- Difficult
- More than 2 hours
-
Pliers, Screw drivers, Socket set
Replaced ‘sump’ housing , seal was leaking on it- replaced inop float on water level warning system switch, and switch itself as well- replaced drain pump motor attached to sump- replaced o-ring seal at water sprayer inlet valve- replaced water inlet plastic assemble on side of dishwasher- replaced drain hose out of sump assembly.
... Read more r />Used YouTube video to understand repair- this is an involved repair in time and complexity- dishwasher eventually gets turned upside down once removed and stripped down, to remove the white plastic water pan , which then allows access to the guts of all the above parts- some critical seals only come with new assemblies, so you are buying that new part to get a new seal and ensure no new leaks from what you took apart.
... Read more r />Used YouTube video to understand repair- this is an involved repair in time and complexity- dishwasher eventually gets turned upside down once removed and stripped down, to remove the white plastic water pan , which then allows access to the guts of all the above parts- some critical seals only come with new assemblies, so you are buying that new part to get a new seal and ensure no new leaks from what you took apart.
Read less
Was this helpful?
Thank you for voting!
Disenser would not hold Finish solution - replaced unit
1 person
found this instruction helpful.
-
Richard from Ashland, OR
- Easy
- 30 - 60 mins
-
Screw drivers
First - I watched 2 or 3 videos on how it was done. The operation was not as easy as the videos made it out to be. Removal of the old unit was straight forward using 6 coins as shims to spread open the metal clips that hold the unit in place was essential. One issue not covered well in the videos is supporting the control panel after it w
... Read more
as removed. the wires hang and are supporting the panel which is not good. I used a bunch of masking tape to secure the control panel to the top of the door. Also - installing the new unit can really only be done by first, fully engaging the top of the dispenser and then forcibly "pushing" (I used a rubber mallet) the bottom into place. you need to make sure the clips are locked in on all sides. After the dispenser is in place and the wiring harness has been reattached, you need to tape the wiring onto the door to keep them out of the way. I then very loosely reattached the control unit by the top 2 screws. I then lowered to the door flat and weighted it down. I used a clamp on each side of the door to lift the cover up into place unit until it could screwed. and then jimmied the control panel into place
Read less
Was this helpful?
Thank you for voting!