DE21CT Maytag Dryer - Instructions

All Instructions for the DE21CT
61 - 75 of 839

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Trying to install the drum belt by reaching in from the front over the top of the blower & motor.
7 of 10 people found this instruction helpful.
  • Wesley from Tulsa, OK
  • A Bit Difficult
  • 1- 2 hours
  • Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
I observed that the top of the dryer was affixed by two screws at each front corner. With these removed the top of the dryer could be easily lifted and with the front support panel removed the drum, drive motor and idler pulley could be accessed. This allowed the installation of a new drum belt in a short period of time. Installing the belt from the front lower left hand side proved very difficult for me but with the top raised and coming in from the top it was accomplished in short order. Thank you, Wesley Harmon
Was this helpful?
Thank you for voting!
door switch broke
9 of 16 people found this instruction helpful.
  • richard from pleasant valley, NY
  • Easy
  • 15 - 30 mins
  • Nutdriver, Screw drivers
remove bottom section under door 2 screws remove door 2 screws remove switch by squeezing tabs install 2 new female ends on wires supplied with switch . put switch back in plug in wires .
Was this helpful?
Thank you for voting!
Door safety switch would not close keeping dryer from running
9 of 16 people found this instruction helpful.
  • John from Warsaw, IL
  • Really Easy
  • Less than 15 mins
Shut off or unplugged dryer for safety.

Slipped thin blade putty knife up under bezel of switch to unlatch from the panel and pulled forward to remove the swwitch from the dryer. Unplugged the quick connect terminals (3) from the old switch and plugged them onto the new switch. one of the terminals had gotten quite hot and da rkened the insulation so it was replaced with one that was supplied with the switch. that was a cut, strip, crimp process. Placed the new switch into the panel and snapped into place.
Was this helpful?
Thank you for voting!
noisy
7 of 11 people found this instruction helpful.
  • Hazel from CONNERSVILLE, IN
  • A Bit Difficult
  • More than 2 hours
  • Nutdriver, Screw drivers, Socket set
I watched the video
Was this helpful?
Thank you for voting!
missing, probably broken female latch part
5 of 5 people found this instruction helpful.
  • claude from laguna niguel, CA
  • Really Easy
  • Less than 15 mins
Press in the new female latch part with thumbs. Took about two seconds!
Was this helpful?
Thank you for voting!
Dryer would not stay closed.
5 of 5 people found this instruction helpful.
  • karl from monroe, GA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I used a flat screw driver to pop out the old female portion and snapped in the new one. Dryer stays shut. That's it!
Was this helpful?
Thank you for voting!
Noisy Dryer operation and eventually no air movement through dryer
5 of 5 people found this instruction helpful.
  • Russell from ELK GROVE, CA
  • Easy
  • 30 - 60 mins
Every two to three years, the blower wheel gets chewed out in the center where it attaches to the motor shaft. I have learned the sound of it starting to rattle so I know to order a new blower before the air stops moving altogether. Replacing it is very easy if you have tiny sockets or nut drivers and a pair of snap ring pliers.