DE212 Maytag Dryer - Parts

This thermal fuse mounts on your dryer's blower wheel housing. It will cut out once your dryer's internal temperature reaches 183 degrees Fahrenheit, and will not cut in again. Like a house fuse, you will have to replace it when it blows.

A dryer's idler pulley wheel serves to help the belt to rotate the drum. This arm is what attaches to the idler pulley wheel.

If your dryer isn’t heating properly, this adjustable thermostat kit could be the solution. It helps keep the dryer at the right temperature by turning the heat on and off as needed. You can set it anywhere between 135°F and 155°F, and it kicks the heat back on when the temperature drops by 20°F. The kit comes with everything you need—the...Read morermostat, jumper wires, and wire nuts—and is a great fix for dryers that aren’t warming up like they should.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This thermostat is used for Canadian models only.

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

The tumbler seal can be used for the front or rear. Sold individually.

This part moves the clothes around inside your dryer and helps to direct the flow of hot during the drying cycle.

Sold Individually.

This kit comes with two ceramic insulators.

The blower housing seal makes an airtight seal between the blower housing and the blower housing cover in the dryer.