My Orders
DE180 Maytag Dryer - Overview
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
$33.28
In Stock
Drum Support Roller Kit
Part #12001541
This drum support roller includes one drum roller and two bearings. Most dryers use two drum rollers, and it is recommended to change both at once.
$37.35
In Stock
Tumbler and Motor Belt
Part #WPY312959
The tumbler and motor belt in your dryer allows the drum to spin during the drying cycle. At 100 inches in length, this dryer drum belt is 3/8 of an inch wide and has five ridges. The belt is black in color and it is made entirely of rubber. If your dryer will not tumble, is noisy during operation, or will not start you may need to replac...Read moree the belt. To complete this repair, you will need to remove the front panel as well as the drum. You will need a 5/16 nut driver and a stubby Phillips screwdriver to complete the repair. Be sure to disconnect power to the dryer before you begin this repair. During the repair, make sure the belt doesn't fall into the groove in the drum, which will cause it to be too loose. You should be able to access the belt and replace it by removing the front panel and bulkhead.
Read less
$19.14
In Stock
Front Glide Kit
Part #306508
This front glide kit comes with a blue plastic glide, a brown cork pad, and two metallic rivets. Two kits are required per appliance. A rivet tool is required for this installation.
$32.26
In Stock
Blower Wheel with Clamp
Part #Y303836
This blower wheel comes with a metallic hub clamp to hold it firmly in place.
$42.36
In Stock
Lint Filter
Part #WP33001003
This lint filter screen is slide in styl type of Maytag filter screen. It is most typically used for the 08 and later series of Maytag gas or electric clothes dryers that appear before 1990.
$25.19
In Stock
Idler Pulley Wheel
Part #WP6-3037050
This part is used to help the belt to rotate the drum. It is white and made of plastic with a metallic bearing in the center.
$13.84
In Stock
Door Latch Kit
Part #306436
This dryer door latch kit comes in two pieces: a door latch, and a door strike. It's used to help hold your door shut to your dryer.
$39.55
In Stock
$60.45
In Stock
Dryer Heater Element 240v
Part #WPY313538
Made for use with series 08 and later gas and electric clothes dryers, this pre-stretched heating element coil carries 240 volts.
$189.74
In Stock
Drive Motor - 60Hz 115V
Part #W10410999
This dryer drive motor is a genuine OEM replacement part designed to power the drum rotation in select Whirlpool, Maytag, KitchenAid, Jenn-Air, Amana, and Magic Chef dryers. Operating at 115 volts and 60 Hz with a 1/4 horsepower output, it drives the belt that turns the drum, ensuring consistent and efficient drying performance. The updat...Read moreed motor features a redesigned switch and new wire terminals, which may require re-wiring during installation. Common symptoms of a failing motor include the dryer not starting, the drum not turning, or the appliance stopping mid-cycle. Installation should be performed by a qualified technician, and it is essential to verify compatibility with your specific model before ordering.
*Note: part does not come with installation instructions
Read less
$52.75
In Stock
High Limit Thermostat (Limit: 200-30)
Part #WP303396
Keep your dryer safe and running smoothly with this high-limit thermostat. It shuts off the heat when things get too hot—around 200°F—and turns it back on once it cools down to about 170°F. This helps prevent overheating and keeps your laundry routine worry-free. With two easy-to-connect terminals, it fits many dryer models and installs quickly with basic tools.
$382.00
In Stock
Dryer Complete Heater And Housing Assembly 240v
Part #WPY303404
This heating element consists of two pieces: a metal tube and a coil. It carries 240 volts and is approximately 17 inches long with an approximate 7 inch diameter.
Common Symptoms of the DE180
How this model fails, and the parts that fix it.
Noisy
Fixed by
these parts
these parts
Show All
Drum Not Spinning
Fixed by
these parts
these parts
Show All
Door won’t close
Fixed by
these parts
these parts
Show All
Too hot
Fixed by
these parts
these parts
Show All
Marks left on clothes
Fixed by
these parts
these parts
Show All
Not Heating
Fixed by
these parts
these parts
Show All
Won’t Start
Fixed by
these parts
these parts
Show All
Door Pops Open
Fixed by
these parts
these parts
Show All
Running With Door Open
Fixed by
these parts
these parts
Show All
Watch our pros, then fix it yourself.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!
View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
noisy rollers, broken latch
673 of 705 people
found this instruction helpful.
first, I unplug the power supply of the dryer then I removed the two screws at the bottom of the dryer then pulled out the front part of the dryer,unplugged the blue & yellow wire for the on/off switch for the door,at the back of the dryer I unscrew the pannel for the belt,disconect the belt,and I unscrew the four screws on both side of t
... Read more
he front pannel to remove the front cover of the drum. Once I removed the front cover of the drum I can now remove the drum itself to access the drum support roller. I unscrew the rollers then replace it with the new once. It was an easy job.
Thank you.
Thank you.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
electric dryer was rumbling - wheel or belt?
602 of 711 people
found this instruction helpful.
Unplugged dryer. Front came off easily. Removed front of blower. Wheel came off fairly easily - could then see that shaft of motor was circular with flattened side but inside of old wheel was rounded. New wheel popped right on. Took tumbler off so I could clean lint out more easily and get a good view of how the belt threaded through
... Read more
. Put the tumbler back on and reached back with both hands to thread it. Took a half dozen tries until I was sure it was seated correctly and not twisted. Put front... of dryer back on. So far (a week or so) the rumble is gone. Seems blower wheel was the cause of the rumble. Belt didn't seem worn but replaced anyhow.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!