DCS565P1 (Type 1) DeWALT Circular Saw - Parts

This genuine DeWalt replacement blade screw is used to secure the saw blade to the spindle or shaft on your circular saw. Made from strong metal, it’s built to hold the blade firmly in place during cutting. You’ll need a wrench or a hex/Allen key to tighten or loosen the screw during blade changes. It’s sold individually, so be sure to check your saw’s manual to confirm it’s the right fit for your model.

This extension spring is sourced directly from the original equipment manufacturer for Black and Decker and DeWALT drill presses. It is an important component that applies tension on the knob for the edge guide. Over time it may wear out and lose tension eventually requiring a replacement. To ensure the correct installation of this hardwa...Read morere, check the diagrams of your specific model. This high-quality spring is made of a durable metal and is sold as an individual item. Replacing it does not require any tools, remove the knob and replace the spring.

This replacement screw is an authentic manufacturer sourced item. It is commonly used with a variety of power tools. This screw is a standard hardware which has multiple uses based on equipment. To ensure correct location and application of this item please make sure to check appropriate diagrams. It is made out of metal and it is sold in...Read moredividually. Requires a torx or a flat-head screwdriver to tighten/loosen this screw.

This is a genuine replacement inner clamp washer that is supplied directly from original equipment manufacturer. It is used on Dewalt circular saws to secure the saw blade. This metal washer is sold individually. Please note, the outer washer and the blade bolt are both sold separately. You will need a wrench to remove the blade bolt when replacing this washer.

This is an authentic DeWALT and Black & Decker replacement part that is sourced from the original manufacturer for use with saws, grinders, jointers, nibblers, plate joiners, polishers, routers, sanders, and shears. The retaining ring attaches to the ball bearing and is made of metal. When replacing this item an allen wrench and a screwdr...Read moreiver might be required during the installation process. It will need to be replaced if it becomes bent or broken. This part is available as an individual replacement.

This is a genuine replacement part manufactured for use with circular saws. The retaining ring is used to secure the inner blade washer to the spindle shaft. The retaining ring is sold as an individual replacement part.

This is an authentic OEM sourced replacement part that is intended to be used with trim saws, circular saws, and miter saws. The metal spring fits into the blade case or the gearbox. This item is used to provide compression for the spindle lock shaft. The spring is sold as an individual replacement part.