DCS331B (Type 1) DeWALT Jig Saw - Parts

This replacement washer is an authentic component which is supplied by the original equipment manufacturer is specially designed for use with Dewalt jig saws. It helps to distribute the pressure evenly helping to secure the clamp plate, for the correct application please refer to appropriate diagrams of your model. Please note this high-quality part is made of durable rubber material and it is sold individually.

This is an original replacement part designed for use with Dewalt jig saws. This bolt plays an important role because it helps to secure the blade clamp to the unit. This bolt has a hex socket head and it is sold individually. Please only use properly sized hex key/allen wrench to install or remove this bolt.

This is a genuine item that is supplied by the original equipment manufacturer for use with DeWALT jig saws. It is an identical replacement for a missing or a faulty spring that was installed on a new unit. The spring helps to apply tension on the guide bushing. Please make sure to check the appropriate diagrams of your model for the corr...Read moreect location and application of this hardware. Keep in mind this high-quality spring is made of durable metal and is sold individually.

This is an authentic DeWalt replacement part manufactured for use with jigsaws. The actuator is used to release the blade clamp when removing or installing the blades. This actuator is available as an individual replacement part, please see model diagram for associative parts.

The bracket goes next to the nozzle. This item is sold individually. A set of pliers might be helpful during the installation of this part. It will require replacing if it breaks. This is a genuine DeWALT part sourced directly from the manufacturer for use in jigsaws.

This is an authentic DeWALT replacement part. The crank kit is often found in DeWALT jigsaws. This kit includes a metal crank and needle bearing, and is used to turn the circular motion of the gears into the reciprocating motion of the saw blade. A screwdriver will be required when replacing this item. As you remove parts, it is advisable to keep careful track of their order so you can reassemble them correctly.

This is a genuine manufacturer-sourced part which has been designed for use with DeWalt jig saws. The clamp plate secures the sole plate to the shoe, and is sold individually. A hex key is needed for the installation.

This is a genuine DeWALT replacement part sourced directly from the manufacturer. The 12V MAX* Lithium Ion Charger is designed for use with over 40 DeWALT machines. This item is capable of charging all DeWALT 12V - 20V MAX* Li-Ion Batteries in less than 90 minutes. This part is sold individually.