D28605G (Type 1) DeWALT Nibbler & Shears - Parts

This is a genuine DeWalt replacement part that has been sourced from the original manufacturer to be used with cement shears from DeWalt and Black & Decker. The metal gear is used to link the motor's drive shaft and the gearcase assembly. This item is sold as an individual replacement part.

This is a genuine DeWalt replacement power cord, specifically designed for use with double-insulated tools. Built for durability and safety, it features two wires and two prongs, eliminating the need for a ground wire. The cord measures 8 feet in length and uses 18-gauge wiring, offering a reliable connection and flexible reach for your p...Read moreower tool needs. It’s sold individually and is compatible with the models listed below. Installation requires careful attention: the new cord wires must be properly inserted into the wire terminals, and the cord should be routed correctly to avoid pinching when reassembling the tool’s case or plate. For best results, refer to your tool’s manual or consult a professional technician.

This is an authentic Black & Decker replacement part. The terminal is designed by the manufacturer for use in drills, screwdrivers, and shears. This part is made of metal, and is used to create an electrical connection within the machine. You may require a screwdriver or Allen wrench and pliers when replacing this part. This item is sold individually. Included in part number 450562-00

This is an authentic replacement part, sourced from the original manufacturer for use with shears, nibblers, and miter saws from DeWalt and Black & Decker. The metal wrench is used to service the machine. This tool is available as an individual replacement.

Genuine Manufacturer Sourced replacement part used on a variety of Power Tools. This part is made out of Metal and it is sold individually. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces frictio...Read moren. This reduces wear on the tool and allows it to run smoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement. Included in part number 605511-00

It is a genuine replacement screw that is sourced directly from original equipment manufacturer. This is a standard hardware that has multiple uses depending your tool. For correct location and use of this screw, please check appropriate diagrams. This torx screw is sold individually.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

This is an authentic Craftsman replacement part. The cord clamp is designed by the manufacturer for use in drills and hammer drills. This part is made of high-quality plastic, and is used to secure the power cord in the housing. You may require a screwdriver or Allen wrench when replacing this part. This item is sold individually.