D28065 (Type 2) DeWALT Angle Grinder - Parts

The bearing cup is an OEM sourced part that is used with Craftsman angle grinders. This is not an aftermarket imitation part. This item is used to secure the bearing on the commutator side of the armature within the motor housing assembly. This item is available as an individual replacement part.

This replacement guard is a genuine Dewalt item, not an aftermarket equivalent. It is supplied by original equipment manufacturer for use with angle grinders. This part helps to protect the user from the dust and trimmings. Never operate grinder without a guard on, it is extremely dangerous. This part is made out of metal and it is sold i...Read morendividually. This guard comes with a latch mechanism making it very easy to install or remove without the need for any tools. (Enclosed Top)

This OEM DeWalt replacement part is for use with angle grinders. This plastic cover allows access to the carbon brushes for replacement or repair. The cover can become damaged or cracked, and may need to be replaced. One screw is required to install the cover, note the screw is sold separately.

This is a DeWALT replacement part directly sourced from the manufacturer for use in grinders. The brush spring goes next to the brush and the terminal. It is made out of metal and is a small part which means it will need to be replaced if it becomes lost or broken. When replacing this item a screwdriver might be necessary. This spring is available as an individual replacement part.

This is a genuine Dewalt replacement part, it is sold individually. The 648743-00 acts as brush holder for the models listed below. The 636760-00 Brush Spring is positioned behind this part to keep the brush in contact with the armature. There are two of these parts in the tool.

This screw is an original part from DeWalt. The metal screw is often used to secure the brush door of several drills and grinders. This component is sold individually, and a screwdriver is required for the proper installation.