CTT21GABNRAA Hotpoint Refrigerator - Instructions

Using plyers Pulled old switch down and out. Put new one in and pushed new switch up into position. The switch plugs into the contacts, no wiring needed. Worked like a charm. You saved me 200 dollars GE repair bill. Thanks

removed the inside fridge electrical panel and swapped switches

Slid each part into the proper slot, and I was good to go.

Took the old frame apart - two screws - replaced broken side rail and put frame back in frig. replaced glass shelf and bins. Frig good as new. 15 minutes. Pretty good for and 81 year old lady.

Ensured the retainer bar was the correct length. Inserted the shelf ends into the end caps. Snapped the assembled parts into the door.Job done!

easy pry out, disconnect wiring, connect on new switch and press in switch.

followed instructions from video on your site

Your online helpful hints made it easy as pie.

Unscrewed the old rail, cleaned everything and installed the new rail

Both PartSelect and GE advisors told me to remove/loosen screws holding gasket to the door. This model has no screws. After pulling to old gasket from a corner (very difficult) I found that it is held in place by pressing it into a channel running around the door. Very difficult to line up the proper parts and very difficult to slide/adjust it into place. When finally installed, one corner of the gasket protruded so that the door was not flush and actually kept the door from closing. I tried to push/pull it into place. No good. Finally I tried to hammer the gasket back to make it flush. No good, as it evidently crushed the magnets providing the necessary holding power and produced gaps. I finally had to get foam window stripping plus heavy duty magnets to pull door to frame. Result: door closes OK but some moisture collects around door.

Just snapped in the replacement. 15 second repair. I was not completely sure that I had the right one ordered. There were two choices. I selected one and it worked fine.

I was a bit concerned that I might have selected the wrong part. There were several pictures of rails to choose from with slight variations on the website. Fortunately, it was a correct selection and arrived sooner than expected. The assembly was easy to remove from the refigerator. Two screws that held the slide in place were removed and the replacement was installed within minutes. I am very pleased that I chose to use PartSelect.

pull the front cover off, take the two screws out and the side rail comes right off, put the new one in place, put the screws back in and bang!.....all done. Took longer to take the stuff out of the fridge than to make this repair.

First, read through blogs which said it could be something frozen up. I unplugged and let it warm for a few days. Didn't work. No ice found. Then, assumed to be thermostat. Unplug frig. One screw removes cover, then another 2 screws to take out thermostat compartment. Unplug wires from harness and remove. Simply put in the new thermo (reverse from removal), and reassemble. Bingo, nice and cool within 12 hr. Rock solid 35F ever since. Pretty simple.

Just follow instructions