CSB48WP2NKS1 General Electric Refrigerator - Instructions

philip from cocoa, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

Was this instruction helpful to you?

water filter was aged and needed a replacement

unscrew filter and replace the new one

Parts Used:

Richard from La Grande, OR
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

We needed a new water filter.

We received the part just a few days after ordering, unscrewed the old filter by hand, and installed the new filter the same way.

Parts Used:

Dan from Surprise, AZ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Installed whole house filter, did not need refrigerator filter

Removed water filter and inserted plug (works great and water flow increased)

Parts Used:

Refrigerator Bypass

Walter from Temple, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

refrige ws too cold

as per video

Parts Used:

Jeffrey from Saint Charles, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Pliers

Was this instruction helpful to you?

Filter needed replacing

Very easy, unscrew and re-screw new filter in..

Parts Used:

Randell from Rancho Cucamonga, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Little or no flow to water dispenser.

Adding a small amount of water to the filter would resolve the problem for a week or two. So, I thought this was an issue with the filter and decided to try the bypass cap to help zero in on the problem. The bypass cap had no instructions concerning the need for O ring so it was trial and error. The O ring was not needed. After installation of the bypass cap, no water flow resulted and I had to replace the filter. Intermittent problem continues.

Parts Used:

Refrigerator Bypass

Randel from Centreville, VA
Difficulty Level:
A Bit Difficult
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

replace water filter

Easy, with included video and instructions

Parts Used:

Richard from Waynesboro, PA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Fridge was freezing food near the back, adjusting internal temp not fixing the problem

Unplugged the refrigerator first....then on the inside of the fridge, I popped the temp sensor cover off (upper LH side) and exposed the old sensor. I snipped off the old sensor about 3" down from the end and connected the new sensor (which I trimmed down to about 3" long) with some heat shrink wire nuts/connectors. Let the fridge run for a day or so and confirmed the problem was solved! Oh yeah, there was no way to tell the 2 wires apart (power vs. ground) on the sensor. However there was a manufacturer's stamp on the wires. So note the orientation of the text and mark one of the wires with a sharpie on both the old and new sensor before trimming. This will give you a reference for which wires to connect when adding the new sensor to the old wires.

Parts Used:

Zachary from Decatur, GA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

Was this instruction helpful to you?

Both the fridge aqnd freezer would not get cold.

Easy. Followed the video instrucations. the part was right there next to the compressor.

Parts Used:

Run Capacitor

Mary from Farmingdale, NY
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Refrigerator freezing.

Temp. Sensor was under an egg shaped cover on the left side wall in the refrigerator. Remove the cover, cut the two wires to the old sensor and remove it. Connect the new sensor to the two wires using butt connectors. Replace cover and done.

Parts Used:

Wayne from Rancho Cordova, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Evaporator fan motor was whistling

Ironically I did this today, as this email request came up asking how it went. I'm not a repairman, I'm a software engineer, and I can't thank this site enough for the step by step videos. With the video to help, this was a breeze, I was nervous as I had to empty all my freezer out onto the living room floor. Once that was done the repair took about 30 minutes. Thank you partselect!!!!! My second time doing business here, and I'll be coming back (well, if something breaks, so let's hope I don't have to).

Parts Used:

JOHN from SOUTH CHINA, ME
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set

Was this instruction helpful to you?

fan made howling noise

it was easy the only thing was i had to cut old harness to remove 2 wires that went to coil that had to go back in the new harness other then that a peice of cake.

Parts Used:

raymond from peachtree city, GA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver

Was this instruction helpful to you?

fan motor making a moaning sound

followed you online video and it was easy and simple repair only took about an hour frig is back quiet and working fine thanks also parts come fast

Parts Used:

walt from san antonio, TX
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers

Was this instruction helpful to you?

freezer cold fridge warm loud squeeling noise

i followed a video that was on your site, the video couldn't have been easier to follow it was step by step and very easy to follow, i replaced the evaporator fan motor and everything is working fine, i did notice that the evaporator coil was frozen pretty bad when i removed the back freezer panel i am going to check it again in a couple of weeks to make sure i don't have a defrosting problem as of now everything is fine i am hoping it was just the bad fan motor causing the coil to freeze up because of no air movement over the coil

Parts Used: