CLZ8560ADB Magic Chef Cooktop - Instructions

All Instructions for the CLZ8560ADB
1 - 15 of 18

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
The grommets came apart metal from rubber.
24 of 29 people found this instruction helpful.
  • Frank from Pierce, ID
  • Really Easy
  • Less than 15 mins
I replaced the broken grommets with the new ones. I purchased 8 so I would have back ups because I did not feel the new one would last either. I think they cost TOO MUCH but I could not haggle for price.
Was this helpful?
Thank you for voting!
range top loose, grommets missing
12 of 16 people found this instruction helpful.
  • joseph from wildomar, CA
  • Really Easy
  • Less than 15 mins
very easy to push each grommet into range top holes
Was this helpful?
Thank you for voting!
burner would not light
11 of 16 people found this instruction helpful.
  • Albert from Clewiston, FL
  • Easy
  • 15 - 30 mins
  • Pliers, Screw drivers
saw burner tube was completely rusted at end and would not line up with burner. decided to go ahead and replace all three tubes. was easy to install, able to get a good cleaning job on unit in the process. works fine, wife is happy and that is what matters in a motorhome.
Was this helpful?
Thank you for voting!
Inside Of Knob Busted Out, Would Not Turn Ignitor.
7 of 11 people found this instruction helpful.
  • DAVID from SEARCY, AR
  • Really Easy
  • Less than 15 mins
Actually too simply to list as diy job. Merely remove old knob and push new one onto spindle.
Was this helpful?
Thank you for voting!
missing gromet
5 of 8 people found this instruction helpful.
  • Hal from National City, CA
  • Really Easy
  • Less than 15 mins
Pushed into hole by hand, really simple
Was this helpful?
Thank you for voting!
existing grates were very worn.
5 of 9 people found this instruction helpful.
  • Alta from Rexford, MT
  • Really Easy
  • Less than 15 mins
Just ordered a new grate. Everyother place I talked to said the one piece grate would not fit, so I am very pleased with the service you offered.
Was this helpful?
Thank you for voting!
igniter knob for gas stove stripped out
3 of 3 people found this instruction helpful.
  • Brady from CARYVILLE, FL
  • Really Easy
  • 15 - 30 mins
Slip old knob off slide new knob on, be sure to align knob properly your done
Was this helpful?
Thank you for voting!
Wouldn't ignite
2 of 2 people found this instruction helpful.
  • William from ARCHER, FL
  • Really Easy
  • 30 - 60 mins
Pulled knob,removed 2 screws removed wire,removed old ignitor repl. With new reversed procedure,done
Was this helpful?
Thank you for voting!
Bushings were worn out
4 of 9 people found this instruction helpful.
  • Fred from Spring, TX
  • Really Easy
  • Less than 15 mins
The parts were exactly correct. The website was complete and easy to use. The reair was a snap.
Was this helpful?
Thank you for voting!
Igniter failed
2 of 10 people found this instruction helpful.
  • Paul from Niland, CA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
The igniter on our RV stove top failed after 4 years of operation. The repair took about 8 minutes and everything works fine.
Was this helpful?
Thank you for voting!
Knob would not turn igniter.
  • Harvey from Lynchburg, TN
  • Really Easy
  • Less than 15 mins
Simple off/on installation.
Was this helpful?
Thank you for voting!
Lost on of the Rubber Grommet holding the stove grate
  • Martin from Millersburg, MI
  • Really Easy
  • Less than 15 mins
So simple would be embarrassed to give any instructions; it is so self evident.
Was this helpful?
Thank you for voting!
Front flashtube extension rusted through, ignition knob stripped, rubber grommet missing
  • Henry from Omaha, NE
  • Really Easy
  • Less than 15 mins
  • Screw drivers
Removed screws from igniter cover, removed and replaced fron extension tube. Removed old knob and replaced. Replaced missing grommet. Saved other extension tubes as the old ones were still serviceable.
Was this helpful?
Thank you for voting!
flashtube was burned off
  • john from mount vernon, WA
  • Really Easy
  • Less than 15 mins
put in new flashtube
Was this helpful?
Thank you for voting!
range top was missing one of the rubber grommets used to hold the grate.
  • John from Elizabeth, CO
  • Really Easy
  • Less than 15 mins
Just pushed the new grommet into the hole. The grommet fit just fine and took about 10 seconds to install.
Was this helpful?
Thank you for voting!
All Instructions for the CLZ8560ADB
1 - 15 of 18