CG200 - Parts

This surface burner knob is a little under two inches in diameter. It is a black knob with gray numbering indicating the temperature level of the surface burner: low, medium, high, off, and lite. Made entirely of platic, this knob will accept a 'D' shaped shaft.

This grease filter is almost fourteen inches long and almost twelve inches wide. This filter is intended for use with some downdraft cooktops and ranges.

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

This nine-inch black burner fits right onto the front of your gas range and helps deliver even heat while you cook. It’s built to last and designed to work smoothly with your appliance. If your current burner is worn out or not heating properly, this replacement can help restore performance. Just make sure it matches your model before installing.

This glossy black burner sits at the back of your stove and helps deliver steady heat while you cook. It guides the gas to the burner head so your meals cook evenly. If your rear burner isn’t lighting or heating properly, this part could be the fix. It’s a direct replacement and easy to install—just make sure the stove is off and disconnected before starting.

This pan sits under the burner to catch anything that may spill over to make cleaning up easy. Also known as Aeration Pan. Sold individually.

This screw is sold individually.

This burner grate kit contains two burner grates. Each grate in this kit is black and ten inches long.

This blower wheel attaches to the ventilation motor to draw in and exhaust smoke, steam, and cooking vapors, helping maintain clean airflow in your kitchen. Built from durable metal for heat resistance and long-lasting performance, it measures approximately 7 inches in diameter and under 4 inches deep for a secure, efficient fit. Designed...Read more to spin smoothly on the motor shaft, replacing a worn or damaged blower wheel can restore proper airflow, reduce noise, and ensure reliable ventilation performance.

This part is used with down-draft models. It helps draw the steam and odors through the vent when the fan switch is activated.

This spark igniter electrode has a 35" wire lead.

This motor isolator is less than an inch long.