CDG4205AWJ Crosley Dryer - Parts

This part moves the clothes around inside your dryer and helps to direct the flow of hot air during the drying cycle. NOTE: Screws are NOT included.

This part replaces older two terminal switches.

This part moves the clothes around inside your dryer and helps to direct the flow of hot air during the drying cycle.

This arm is what attaches to the idler pulley wheel. The grommet no longer comes with the part as it has been updated by the manufacturer.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This idler shaft retaining ring is well under an inch long and is made of metal.

This screw is sold individually.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

This high limit thermostat is about an inch and a half long. This thermostat will cut out when the internal temperature of your dryer reaches 240 degrees Fahrenheit, and cut back in when the temperature drops forty degrees.

If your dryer isn’t heating properly, this adjustable thermostat kit could be the solution. It helps keep the dryer at the right temperature by turning the heat on and off as needed. You can set it anywhere between 135°F and 155°F, and it kicks the heat back on when the temperature drops by 20°F. The kit comes with everything you need—the...Read morermostat, jumper wires, and wire nuts—and is a great fix for dryers that aren’t warming up like they should.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This thermal fuse mounts on your dryer's blower wheel housing. It will cut out once your dryer's internal temperature reaches around 183 degrees Fahrenheit, and will not cut in again. Like a house fuse, you will have to replace it when it blows. Use it for your Maytag brand gas or electric clothes dryer.