All Installation Instructions for Crosley Dishwasher CDB900NB5A

Plastic piece that held the arm on was worn & dishwasher only 2 yrs old.

Arm screwed on and immediately fixed the problem.

Parts Used:

Upper Spray Arm

elner from new concord, KY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Water did not drain. Found the door latch broken

Unplug dishwasher. Open the door. Remove two Phillips head screws holding the door panel on. Slide door panel down and out to remove. With door still open, remove the six T20 torque screws that hold the control panel. Behind the control is the latch assembly. Take a picture of the wires going into the latch assembly for installation reference(mine was black wires on left and white wires on right). Unplug the two sets of wires. Remove two T20 torque screws that hold the latch. Replace with new latch and reverse steps for installation.

Parts Used:

Latch

Casey from Keota, OK
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Leak

Removed all sealer and install new one as instructed.

Parts Used:

Dishwasher Door Bottom Seal

Dishwasher Tub Gasket - Gray

Reynaldo from ORANGE PARK, FL
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

dishwasher latch

Removed screws for door panel, then literally 2 screws to change out the latch!!

Parts Used:

Latch

scott from Hastings, MI
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

several issues with dishwasher

Easy fix but not cheap
replaced drain trap and four rack wheels with clips

All parts were expensive for the items.
found cheaper wheels w/clips for much less on another site.

Parts Used:

Drain Trap

Nicholas from KESWICK, VA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

The door wasn’t locking

You tube video and it was so easy less than 20min had it fix

Parts Used:

Latch

Michael from FAIRHAVEN, MA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Bottom door seal leaking on my dishwasher

Still have a slight leak, but I'm thinking it may just need time to seat itself.

Parts Used:

Dishwasher Door Bottom Seal

Alex from COMMERCE, GA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

wheels break or bend or fall off

if the wire they snap on was bent it needs to be straightend.......they just snap on. easy to install but wish they had better wheels so this problem would be solved. My 2 sons have same brand dishwashers and have same problem.

Parts Used:

Wheel & Bushing Assembly

ALBERTA from FAIRBANKS, AK
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Water Leaking from Bottom of Door

Replacing the part was easy. Just pop the old one out and pop the new one in. This item fixed my leaking door problem. The old arm had fallen against the heating element, which burned a hole through the end. Water was shooting out that hole and leaking under the bottom door seal. Replacing the door seal did not help, but replacing the arm fixed the leak.

Parts Used:

Lower Spray Arm

Loren from Sacramento, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Leaking Dishwasher

The old gasket was worn. I pulled out the old one, put in the new gasket. I trimmed the ends to fit and that was it.

Parts Used:

Dishwasher Tub Gasket - Gray

Andre from La Mirada, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Lower sprayer arm melted after being lodged

Pulled the old one off and pressed the new one on (plastic clips hold it on). Dishes much cleaner now.

Parts Used:

Lower Spray Arm

james from PENTWATER, MI
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Dish washer leaking at the door

Pulled off the old gasket and replaced it the same way with the new one.

Parts Used:

Dishwasher Tub Gasket - Gray

Brian from Milford, MA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Cutlery basket

Simply took the old one out, and put the new one in.

Parts Used:

Silverware Basket

Mena from Sarasota, AL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

the end on one of the door springs on the dishwasher broke off

I removed the access panel using a nut driver. One fastener on each side at the lower front panel. Move the two piece lower panel and set aside. Locate the broken spring. It will be on the floor under the dish washer. Remove the broken spring. Place the new spring end in the hole in the chord end and place the chord over the plastic guide. Use a pliers to stretch the spring and fasten it to the hole in the lower dishwasher frame at the back of the dishwasher. Check the door for proper tension. Replace the lower panel and secure with the two screws. I recommend replacing both springs at the same time to insure proper balance. If you only replace one spring you will be replacing the other in the near future.

Parts Used: