CAP60P-OF Bostitch Compressor - Parts

The connecting rod cover goes between the intake reed valve and the piston ring. This is available as an individual replacement part and is made of metal. It is a genuine Bostitch replacement part for use in compressors. An allen wrench might be needed during the installation process. This item may become broken and will need to be replaced.

This is a genuine Bostitch replacement part, it is sold individually. The purpose of the Valve Plate is to allow into the cylinder....Read morento the air tank. Overtime the reeds will become worn and the Valve Plate will need to be replaced. This is also a good time to replace the head gaskets.

Read less

Genuine Bostitch replacement part, this item is sold individually. There are two of these gaskets used on the compressor models shown below. They are placed in between the AB-A640050 Valve Plate Assembly. The purpose of the gaskets is to create a seal so air will not leak out. Over time these will wear and have to be replaced. This would be a good time to inspect the Valve plate Assembly for wear also.

This is a genuine OEM sourced component which is specially designed for use with Bostitch air compressors. The head sits at the top of the pump to route air through the compressor and to dissipate heat. It is an identical replacement for a missing or a damaged pump head that was installed on a new unit. Please make sure to check the appro...Read morepriate diagrams of your model for the correct location and application of this part. This high-quality pump head is made of durable metal and is sold individually, keep in mind the hardware to secure it is sold separately.