BGA452F (Type 1) Makita Grinder - Parts

This compression spring is a genuine Makita replacement part. This part is sold individually.

This is a genuine Makita part sourced directly from the manufacturer for use in drills, grinders, impact drivers, impact wrenches, jointers, saws, planers, rotary hammers, sanders, and shears. The flat washer goes next to the vice plate and is made of metal. A screwdriver may be necessary during the installation of this item. It may becom...Read moree broken and will need to be replaced. This is available as an individual replacement part.

This is an authentic replacement part manufactured for use with Makita drills and angle grinders. The woodruff key is used with several different models of equipment and is commonly used to link a spindle shaft and a gear. This woodruff key is available as an individual replacement part, please see model diagram for associative parts.

The shoulder pin attaches to the gear housing. This part is available as an individual replacement. It is an OEM replacement part for use in Makita grinders. A set of pliers might be necessary during the installation of this item. It is made of metal and will need to be replaced if it becomes broken or bent.

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it has multiple applications based on your tool. Please refer to diagrams for correct application.

The pan head screw attaches to the wheel cover. Keep in mind this part is made of metal and is sold individually. It is an authentic OEM sourced item which is specially produced for use with Makita grinders. A phillips screwdriver may be necessary during the installation of this part. Over time it may break or strip and will need to be replaced.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

The endbell goes between the yoke unit and the housing set and is available individually. This is an authentic replacement part sourced from the original manufacturer for use with Makita grinders. It is made out of plastic and metal and will need to be replaced if it becomes broken. A screwdriver may be needed during the installation of this part.

This is an authentic OEM sourced replacement brush cap. It is specially designed for Makita power tools. The purpose of the brush cap is to secure the carbon brush in the holder. Please note, this plastic item is sold individually. You would need a flathead screwdriver to install or remove this brush cap.