All Installation Instructions for Amana Refrigerator ASI2175GRB09

Replace water filter

Open door and from appliance instruction book
Replace filter

Parts Used:

Refrigerator Ice and Water Filter

Jeanne from COSTA MESA, CA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

4 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Freezer ice maker not dispensing ice.

Ordered Ice Bin Auger and changed with no problem. Found how to change on YouTube and followed video.

Parts Used:

Refrigerator Ice Bin Auger Drum

Johnny from MORGAN CITY, LA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

freezer (later fridge too) wouldn't stay cold~

****Make are you order Capacitor & Starter relay too (we ordered separtely so had to pay shipping twice)**** Super easy just open access panel on back near compressor and remove retention clip with fingers, remove & replace both capacitor & starter, put clip and access panel back on, plug in and allow 8 hours to cool! Works like new again! Hope it goes another 10 years

Parts Used:

Refrigerator Capacitor

David from MARYLAND HTS, MO
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Auger blades separated from hub.

First I removed the screw holding the ice door shaft (at the rear of the ice container). Removed clip of which the screw was holding in place (no need to remove the clip from the shaft). Then I removed the front cover screws, separated front cover from ice container. Door shaft is removed with front cover assembly, no need to remove anything else from front cover. Pulled out auger shaft, removed circlip (snap ring) and washer from front of shaft. Used an adjustable wrench to remove plastic nut from front end of shaft. CAUTION - the plastic nut is reverse thread, make sure to turn it clockwise to loosen and remove. Pulled off broken auger then reassembled with new auger in the reverse order as previously described.

Parts Used:

Refrigerator Ice Bin Auger Drum

Randolph from Derby, KS
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Wrench (Adjustable)

3 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Freezer drawer light switch failure.

Disconnect plug from wall. Insert putty knife between light switch.and trim panel , apply pressure to depress plastic spring holding switch in place. Apply a slight twist too putty knife releasing switch from trim piece. This wil expose plug connected to switch. Disconnect plug from switch. Connect new switch to plug. Insert switch into trim. Plug refrigerator into wall socket.

Parts Used:

Door Switch

HARRY from FSTRVL TRVOSE, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Light switch on door broke

Popped out broken switch with blunt flat edged instrument. Disconnected switch from unit . Plugged new piece in and reinserted into side panel of refrigerator. Very easy.

Parts Used:

Door Switch

Donna from Oro Valley, AZ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 6 people found this instruction helpful.

Was this instruction helpful to you?

The door switch was broken so the interior light would not come on.

The instructions in the package were not helpful. They wanted me to cut the wiring harness and described where to cut based on the wire colors. My wires were not the same color! I removed the light mechanism using a combination of a screwdriver, putty knife, and plain old muscle with my fingers! The wiring harness unplugged easily and the new one inserted. It was easy to push the whole assembly back into the door. I spent more time looking for something to cut the wiring harness with (and never did find it) than the whole job actually took without needing to cut anything!

Parts Used:

Door Switch

Catherine from BROOMALL, PA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

freezer and refrigerator compartments not cold enough

Used the suggested problem list here to narrow down that the repair was most likely the run capacitor. Poped the new one in and I now have better control of my compartment ranges. I have a temperature gauge in each compartment. Check them every opening of the doors.

Parts Used:

Refrigerator Capacitor

Michael from Colorado Springs, CO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

1 person found this instruction helpful.

Was this instruction helpful to you?

Freezer occasionally had a temperature alarm.Clicking noise also.

Was told capacitor was problem 90% of the time.Capacior was not the problem.Bad start relay.

Parts Used:

Refrigerator Capacitor

Barry from FORD CITY, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Ice dispenser not working.

All I did was unscrew the stripped one and screw the new part on. You just have to get it started unscrewing first ( remember that it's backwards! ).

Parts Used:

Refrigerator Ice Dispenser Motor Coupling

Kerby from BEVERLEY HILLS, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Plugged it in.

Not so good that was not the problem. Fan is not seized and all the lights work and display is not on but lights up as well. No start once plugged back in after 15 minutes of being unplugged. Nothing same no change.

Parts Used:

Refrigerator Capacitor

Adam from GLOVERSVILLE, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

1 person found this instruction helpful.

Was this instruction helpful to you?

Light out.

Popped out the old switch and replaced it with the one dying

Parts Used:

Door Switch

Carlton from CHICAGO, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

I CRACKED THE DRAWER REMOVING IT FOR WASHING

Tilted the drawer upwards and slide it in according to instructions.had no issues just need to make sure you have maneuvering room for taking out and putting it back in.

Parts Used: