AS829CSBGB Maytag Refrigerator - Parts

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

This is the replacement water filter for your refrigerator. It is white in color with a red cap, and is approximately 3 inches wide and six inches tall. The water filter reduces contaminants and improves taste in your refrigerator water supply. It is recommended to replace the water filter every six months. You will find the water filter ...Read moreat the back, top portion of your fresh food compartment. To remove the filter, simply twist it to the left until it can be removed. Then, remove the cap on the new filter, line up the arrow with the indentation, and twist to the right until it is secure. You may want to put a towel down below the filter when completing this repair, to catch any spills or drips. When you replace the water filter, hold down the dispenser trigger for a few minutes so that all the air is purged from the water lines, and the water tank fills up. This is an OEM part and is sold individually.

Sold individually.

This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

This icemaker water inlet cup is three inches long. It is all white in color and is made of plastic.

This part is also known as the cycling thermostat and this bi-metal device controls the activation of the icemaker ejection cycle.

Sold individually.

This limit switch is located in the ice/water dispenser section. The switch pictured here is black, though this type of switch is also available in white.

Sold Individually.

This plug comes with a black rubber seal ring.

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.

This screw is sold individually.