AGR6603SFB3 Maytag Range - Parts

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

This oven temperature sensor is designed to monitor and regulate the internal heat levels of your range, ensuring consistent and accurate cooking performance. It communicates directly with the control board to adjust heating as needed. Over time, exposure to high temperatures can cause the sensor to degrade, leading to uneven heating or f...Read moreailure to maintain set temperatures. If your oven struggles to reach or hold the correct temperature, replacing the sensor may resolve the issue. This OEM replacement part includes a wire harness for connection and is installed using two mounting screws. Installation is simple and typically requires only a screwdriver. Please note that the sensor is sold individually and does not include additional hardware.

Oven Wrap Insulation.

The light socket on your electric range connects the power source to the light bulb. If your oven light is malfunctioning, you may need to replace the light socket. The light socket is located in the back of your range, so in order to access it you will need to remove the back panel. Many of our customers have rated this repair as easy, a...Read morend it should take less than 15 minutes. Before you begin this repair, make sure to disconnect the power source from your range. This is an OEM part sourced directly from the manufacturer.

This oven rack offers a sturdy, chrome-finished surface for baking, roasting, and broiling in your range. It fits a wide selection of compatible ovens and is built to handle high heat and frequent use. If your current rack is bent, rusted, or missing, this replacement restores safe and reliable cooking support. Be sure to check your oven model for compatibility. Sold separately.

This part helps your gas oven light properly. It creates the spark that ignites the burner and works with the safety valve to make sure everything runs safely. If your oven isn’t heating, only gets a little warm, or the igniter glows but doesn’t light the flame, this part might need replacing. It fits many Whirlpool, KitchenAid, and Mayta...Read moreg ranges and is built to last. Be sure to turn off the power and gas before installing.

Sold individually.

Give your oven door a clean, finished look with this white side trim piece. It fits on the right edge of the door, helping seal in heat and protect the glass. If your current trim is cracked or loose, replacing it can improve both the look and performance of your oven. You’ll need to take the door apart a bit to install it, but it’s a solid fix for a worn-out part.

Screws are not included with the trim. Must order screws separately.

This broiler pan and roasting rack set features a two-piece design that allows fat to drain away for cleaner cooking and reduced splatter. Made with a durable, high-heat resistant porcelain finish, it offers reliable performance and easy cleanup. Measuring approximately 16 3/4 inches long by 12 3/4 inches wide and 1 3/4 inches high, it provides a practical solution for everyday broiling and roasting.

This kit helps your range drawer open and close smoothly again. It comes with two glides—one for each side—and is a great fix if your drawer is sticking or hard to move. Made for Whirlpool and related brands, it’s easy to install with basic tools. Just check your model number to make sure it’s the right fit.