AGM359 Amana Dryer - Parts

This gas dryer ignition coil set comes with two ignition coils: one three-terminal boost/hold coil, and one two terminal secondary coil. Usually only one of them burns out but you should replace them as a set. Both have to be operational for the gas valve to open.

This dryer drum belt from Amana has five ridges and is 93-3/8" inches in length, and 3/8 of an inch wide. It is flat, black in color, and is made entirely of rubber.

This kit comes in two pieces: the catch and the clip.

This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and ...Read moreis made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.

This two inch wide idler pulley wheel is beige in color and is made of plastic. This pulley wheel comes with its own metallic bearing in its center.

This part replaces older two terminal switches.

This screw is sold individually.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

This metal retaining ring is well under an inch long. Use it for your Maytag brand clothes washer or your clothes dryer.

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

Part may differ in appearance, but functions same as original part.