Models > ADB1400AGB0 > Instructions

ADB1400AGB0 Amana Dishwasher - Instructions

All Instructions for the ADB1400AGB0
106 - 120 of 144
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Heater element snapped in two.
Disconnected power,water supply and drain.Had to pull dishwasher out to access the heater element nuts. Removed broken element and replaced with new part. Repair very easy!
Parts Used:
Dishwasher Heating Element
  • Steve from The Colony, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Spray bar kept coming off. Burned up
Snapped on and ran diswaher. Bottom spray bar flew off burned out.
Parts Used:
Lower Spray Arm
  • Leo from SAN ANGELO, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
snap
Just snap it in
Parts Used:
Rack Track Stop
  • William from MCMURRAY, PA
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
2 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Stop broke
Looked at how the other was installed oh and bought 2 for when the other one fails. Great customer service!!!!
Parts Used:
Rack Track Stop
  • Melissa from JACKSONVILLE, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
dishwasher didn't drain.
Replaced the pump.That wasn't the problem --- if I had it to start over, I'd pull the drain hoses and run the dishwasher to see what water is flowing where. I had a clogged drain --- and maybe something else. Still working through the details.
Parts Used:
Dishwasher Drain Pump
  • Bart from Ellicott City, MD
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
DISHWASHER WOULD NOT FILL WITH WATER
Unscrewed bottom panel of the dishwasher and simply replaced the bad control switch with the new one.
Parts Used:
Overfill Control Switch
  • TRACEY ANN from BRICK, NJ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
1 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Leak in hose
Turned water off. Removed dishwasher from under the counter, replaced hose, reinstalled dishwasher under the counter.
Parts Used:
Drain Hose
  • Lena from Napoleonville, LA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Nutdriver, Wrench (Adjustable)
2 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Tines where falling off old rack
The dishwasher is 25 years old. Ordering the part was simple. Very good web site and user friendly. The shipment and delivery perfect. Part arrived as predicted. Tracking delivery was also perfect. Part was exactly what I needed. The only hitch was that there were no instructions for assembly, not even a drawing of the assembly to give a hint as how to assemble. Therefiore assembly took longer than it should have. However the diswasher is back in operation and I am pleased with the results.
Parts Used:
Upper Dishrack
  • RONALD from EAST GREENWICH, RI
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
4 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The Dishwasher was not firmly connected to the counter
Very simple repair when you're supplied with the proper parts. Their delivery time is exceptional !
Parts Used:
Mounting Bracket
  • Antony from Lakewood Ranch, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
hose had a hole and leaked
I pulled the dishwasher out from the countertop rolled it to the side removed old clamps and hose installed new hose in kind used different hose clamps than provided turned up right pushed back in ran a cycle while looking underneath with a flashlight and saw no leaks and dishwasher has been back in use for a week now.Chris
Parts Used:
HOSE
  • Christopher from Delaware City, DE
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Clean light was flashing and washer would not start
Replaced heating element and high limit thermostat. Was suppose to fix the problem but did not. Replaced the control board and works now. All of these are easy to replace.
Parts Used:
High Limit Thermostat
  • Raymond from Beach, ND
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
My dishwasher quietpartner ii was not cleaning my dishes. It seemed it was not heating correctly that the Hi temp wash or the heated dry.
I loooked up the main problems associated with that model which is provided on the website and ended up ordering a heating element and a thermostat. I replaced both parts it took me about 30 minutes. The dishwasher is working again and my wife is very happy. Thanks guys!!!
Parts Used:
Dishwasher Heating Element High Limit Thermostat
  • Jesus from Tucson, AZ
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers, Wrench (Adjustable)
0 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
just wanted to replace the upper dish rack - the pieces have been rusting through
no instructions came unfortunately, but it wasn't too difficult reverse engineering. took the upper rack out, disassembled it and put the new rack together using the old screws (since there were no screws either with the replacement rack). There are some extra parts I don't know quite what to do with - some type of additional separators, but the rack works fine without them.
Parts Used:
Upper Dishrack
  • George from Monterey, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
2 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwasher lower rack - rusting
Took out old dishwasher rack and replaced with new.
Parts Used:
Lower Dishrack Kit
  • Eleanor from Elko, NV
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Heat element broken
Removed unit from counter. Replaced element.
Parts Used:
Dishwasher Heating Element
  • Dana from Palm City, FL
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Screw drivers, Socket set, Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the ADB1400AGB0
106 - 120 of 144
Back to Top