ACSL10120H2 (Type 2) DeVilbiss Compressor - Parts

When using an air compressor, moisture naturally builds up inside the tank as air is compressed. If this water isn’t drained regularly, it can lead to internal rust and damage over time. That’s where the drain valve comes in—it allows you to release the built-up water and keep your tank in good condition. Located at the bottom of the tank...Read more, this valve should be opened after each use to prevent corrosion and extend the life of your compressor. If you tend to leave air in the tank for long periods, water accumulation can be even more significant. This replacement drain valve features a thread size of 18 TPI and is sold individually. Regular maintenance with a working drain valve helps ensure safe and efficient compressor operation.

It is an OEM component which is designed for use with air compressors. This special nut sleeve assembly secures the pressure relief tube to the pressure switch. It is a high-quality replacement for a damaged or a missing hardware that was installed on a new unit. One durable metal nut sleeve assembly is included. A wrench will be needed t...Read moreo perform this repair. Check the appropriate diagrams for your model to ensure the proper replacement procedure. Make sure to drain the air before starting this repair.

This is a genuine replacement part manufactured for use with air compressors. The sight glass is used to monitor the oil level inside the pump crankcase. This sight glass is sold as an individual replacement part.

This is a genuine DeVilbiss part for use with air compressors. The safety valve attaches to the manifold and pops open to relieve air pressure if the pressure switch fails to shut off the pump at the cut-off pressure setting. The most common reasons for replacing the safety valve is if the Valve is fouled/damaged or the air compressor run...Read mores for a while then turns off. This part is sold individually. The tools that you will need to replace the safety valve is a Phillip's screwdriver and a Ratchet/socket set.

This is a Genuine Manufacturer Approved replacement part designed to work with a variety of Air Compressors. The pressure switch tells your compressor when to stop and when to start. There are multiple reasons a Pressure Switch could be leaking air. If it is leaking air the Pressure Switch should be replaced for a compressor to operate properly and safely.

Thread 18 TPI