A284 Maytag Washer - Parts

Requires two washers.

This kit is part of the lid switch mechanism and will stop the spin cycle if the load is unbalanced. When you lift the lid, it resets the plunger and your cycle will resume.

This clip is designed to hold a timer knob in place.

This clamp does include the nuts and bolts to hold it together but it does not include the rubber seal. Sold separately.

This timer knob spring is almost an inch and a half long, and is not quite an inch in diameter. It is made of metal and is used with the timer knobs of both washers and dryers.

This center seal retaining washer is a little over an inch in diameter. It is made of metal.

Got a problem with your washer? Meet your solution: the Pinion Gear from Whirlpool. This isn't just any part'it's a genuine, OEM part specifically designed for your washer. Nestled right inside your washer's transmission, this part works hard to keep things turning smoothly. Why is it important? Because it keeps the internal gears movin...Read moreg. Now, here's a handy tip'when replacing this part, it's a good idea to replace the drive gear too. This ensures they wear evenly and work hand in hand to keep your washer working as it should. Getting your washer back to running like a dream is important, right? Then let's get you up and running. First things first, make sure your washer is unplugged and the water is turned off for your safety. It's also a good idea to put on some work gloves before you start'the last thing you need is a bump or a scrape during installation. Trust in Whirlpool and trust in this Pinion Gear. It's just what you need to restore your washer to its former glory.

This two speed split phase washing machine motor performs 1725 revolutions per minute in one speed and 1140 revolutions per minute in the other speed. This motor runs at 1/2 horsepower and it carries 8.0 amps. It's a good idea to change your washer's belts at the same time as you replace this motor, as they may have become worn as well.

10 - 16 x .375

This lid switch actuator spring is exactly one inch long. It is made of metal.