960420221 Craftsman Lawn Tractor - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Wheel bushings were bad
29 of 48 people
found this instruction helpful.
-
Anthony from OLIVEHILL, TN
- Easy
- 15 - 30 mins
-
Pliers, Screw drivers
Removed old clip removed rim from tractor, removed grease fitting on rim, took hammer and screw driver knocked out old bushing turned rim over knocked out other bushing. Press in new bushings reinstalled grease fitting slide tire back on tractor, put retaining washers on then locking clip put on dust cover grease at grease fitting. Repeat
... Read more
other side.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Right axle bent
1 person
found this instruction helpful.
-
MATTHEW from PENNSBURG, PA
- Very Difficult
- 30 - 60 mins
-
Pliers, Screw drivers, Wrench (Adjustable)
Replacing belt with no problem. I've ordered the front right axle spindle assembly three times. This is from your parts list and you sent me the part and they did not work at all.
Was this helpful?
Thank you for voting!
Worn out Mandrel Assemblies
2 of 6 people
found this instruction helpful.
-
Joseph from CANBY, MN
- Difficult
- More than 2 hours
-
Socket set
Remove Deck, Remove Blades, Remove guards and belt, use old belt to hold pully to remove pully (would be good to have pully wrench), Remove mandrel Assembly, Install new mandrel assemblies (had to tap the new mandrel assemblies. Should have been done by manufacturer.). Reinstall blades, guards, and belt. Put deck back on.
Was this helpful?
Thank you for voting!
Dryer runs no heat
2 of 9 people
found this instruction helpful.
-
Russell from MACON, GA
- Easy
- 15 - 30 mins
-
Screw drivers
Disassemble dryer. Replaced element assembly. Re assembled dryer. Unit runs and heats.
Other Parts Used:
Was this helpful?
Thank you for voting!