9566PCV (Type-1) Makita Sander Grinder - Parts

This is an authentic Makita replacement part manufactured for use with angle grinders and circular saws. The sealed bearing is used to reduce friction between a rotating shaft and fixed housing or assembly. This bearing is often used to allow the spindle to rotate inside the gear box, but may have other uses. Please see model diagram for part location and usage. This bearing is sold individually.

This is an authentic part made by original manufacturer. This bearing is compatible with various Makita power tools. A bearing serves to separate and buffer moving parts. It also keeps the moving parts in position while still allowing them to move/turn as needed. As a high-wear part, bearings are often replaced. This item sold individually. Washers and retainers sold separately.

It is a genuine item that is supplied by the original manufacturer for use with Makita angle grinders. The purpose of an o-ring is to provide an air-tight seal between connected components, over time it may wear out and begin to fail eventually requiring a replacement. Please make sure to check the appropriate diagrams of your model for t...Read morehe correct location and application of this hardware. Keep in mind this high-quality item is made of durable rubber and is sold individually.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling ...Read more• O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. • Abrasion • One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. • Over Compression • O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. • Heat Hardening • O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. • Weather/Ozone Cracking • O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.

This part is available as an individual replacement. The lock spring goes between the retaining ring and the spiral bevel gear. An allen wrench, a screwdriver, and a set of pliers may be helpful when replacing this part. It will need to be replaced if it becomes broken. This is an original Makita part for grinders and is made of metal.

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with angle grinders. The plastic fan attaches to the front of the armature and is used to draw air around the motor while the armature rotates. This item is available as an individual replacement part.

it is an authentic high quality Makita replacement part that is specially manufactured for use with sanders and grinders. This is the insulation washer for the armature, please make sure to check appropriate diagrams for correct location and use of this item. One durable plastic washer is included per order.

This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Makita angle grinders. The cord protector fits through the opening in the housing where the power cord is wired, it will protect the base of the cord from getting bent or pinched. This part is made of rubber and is sold individually. ...Read moreFor installation, you will need a screwdriver and a pair of needle nose pliers to aid you.

This part is available as an individual replacement part. The magnet sleeve goes between the stop ring and the wave washer. It is made of plastic and will require replacing if it becomes broken. A screwdriver may be needed when replacing the sleeve. This genuine item is supplied by the original equipment manufacturer for use with Makita sanders, grinders, trimmers, and jigsaws.