9526PB Makita Angle Grinder - Parts

Genuine Makita replacement part. This phillips pan-head screw is sold individually.

This compression spring is a genuine Makita replacement part. This part is sold individually.

This is an authentic OEM part which is designed for Makita power tools. It is an identical replacement for a damaged or a faulty retaining ring that was installed on a new unit. Check the appropriate diagrams for your model for the exact location and the correct application of this retaining ring. You will need pliers toremove the old part and secure the new one. One durable metal retaining ring is included.

This pin 4 is an original part from Makita. The metal pin is compatible with several grinder and router power tools. Often used to secure gear housing components, this item is sold individually. A screwdriver and needle-nose pliers may be necessary for the removal and replacement.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

This replacement tapping screw is an authentic item that is supplied by the original manufacturer for use with Makita power tools. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams for correct location and use of this part. This high-quality phillips pan-head screw is made of durable metal and it is sold individually.

This is an authentic Makita replacement part that is sourced from the original manufacturer for use with grinders, impact drivers, die grinders, chainsaws, and impact wrenches. The tapping screw is used with several different types of tools and the application of the screw can vary based on the model of equipment. The screw is sold as an individual replacement part.

This is a genuine manufacturer-sourced replacement part which is specially designed for use with Makita power tools. The purpose of the brush cap is to secure the brush in the housing, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality cap is made of durable plastic and is sold individually.

It is a genuine manufacturer-approved component which is specially designed for use with Makita angle grinders. It is the part of the tool handling on/off operations, unfortunately, over time parts will wear out and it may begin to fail eventually requiring a replacement. Keep in mind this high-quality plastic body switch is sold individu...Read moreally. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this part.

Length 8 Foot Length: 6' Gauge: 18 Wires: 2 Type: Bare Wire This power supply cord is a genuine OEM sourced replacement part. It is specially made to supply power from a standard outlet to Makita power tools. A cracked or damaged cord should be replaced before continuing to use the tool. This rubber insulated cord is sold individ...Read moreually. It comes with a rubber sleeve grommet that is not sold separately. Replacing this power supply cord you will need a screwdriver. • Remove the housing screws • Remove the the housing • Disconnect the old cord wires • Remove the old power cord • Secure the new cord in place • Connect the wires • Reassemble and test the new cord

This is a genuine Makita replacement tapping screw. It is sourced directly from original equipment manufacturer for use with a variety of power tools. This hardware has multiple uses depending on your tool. Please make sure to check appropriate diagrams for correct location and application of this item. This pan-head tapping screw is sold individually. You will need a screwdriver to install or remove it.