919167211 Craftsman Compressor - Parts

This is a genuine DeVilbiss replacement part sourced directly from the manufacturer. The connecting cap is found in compressors from DeVilbiss, Porter Cable, and Black & Decker. This part is made of metal and is attached to the connecting rod in the motor. You will require a screwdriver or Allen wrench when replacing this part. This item is sold individually.

This is an authentic Craftsman replacement part, sourced from the original manufacturer for use with air compressors. The hex head screw is used to secure the motor assembly to the bracket on the tank of the compressor. These screws are sold in packs of eight pieces and the packs are sold individually.

It is a genuine item that is supplied by the original equipment manufacturer for use with Craftsman equipment. This is a high-quality replacement for a missing or a damaged o-ring which provides an air-tight seal between connected parts. Please make sure to refer to the appropriate diagrams of your model for the correct location and appli...Read morecation of this component. Keep in mind it is made of high-quality rubber and is sold in a pack of eight.

This is a genuine replacement part sourced from the original manufacturer for use with air compressors. The special five-pack of nuts are commonly used to fasten the bolt that connects the wheel to the frame. This nut five-pack is available as an individual replacement part, please see model diagram for associative parts.

This is an OEM part sourced directly from the manufacturer. The tube is commonly found in Craftsman air compressors. This part is made of metal, and is used to carry compressed air from the cylinder assembly to the tank. You will require a wrench when replacing this item. The tube is available as an individual replacement part.

This safety valve is a genuine replacement part manufactured for use with air compressors. If the compressor's pressure switch malfunctions, and does not turn the motor off when the amount of pressure is met, the safety valve will open to release the extra air pressure. The amount of pressure required to open the safety valve is set by te...Read morension of the spring inside the valve. The spring can wear out, and leave the valve open at a lower pressure than what is set to turn the switch off, and will not allow pressure to build inside the tank. This safety valve has a thread sealant pre-applied, so additional thread sealant is not required, the safety valve is sold individually.

When using an air compressor, moisture naturally builds up inside the tank as air is compressed. If this water isn’t drained regularly, it can lead to internal rust and damage over time. That’s where the drain valve comes in—it allows you to release the built-up water and keep your tank in good condition. Located at the bottom of the tank...Read more, this valve should be opened after each use to prevent corrosion and extend the life of your compressor. If you tend to leave air in the tank for long periods, water accumulation can be even more significant. This replacement drain valve features a thread size of 18 TPI and is sold individually. Regular maintenance with a working drain valve helps ensure safe and efficient compressor operation.