91142456590 Kenmore Cooktop - Instructions

The repair was simple but for one missing bit of information. I could not determine how the glass control plate was attached to the cook top. Even GE's tech support wouldn't share any info. I turned out to be, effectively, glued down with a continuous bead of silicone. Once that was determined, I was able to safely and gently pry the glass plate off of the top in order to access a final screw needed to release the control switch.

removed old unit & installed new one

It only took a few minutes to remove the old drip bowls and insert the new ones. No harder than cleaning! It's nice to cook things on my range now and not have drip bowls with scorched on food causing a fire hazard or setting off the smoke alarms.

changed burner and replace light receptical. easy job great service from supplier.

Parts were perfect and very easy to install. Watched the video, no problems

We did the repair by following the inclosed instructions. we are elderly retired average ages 82. This was our first repair and it went very well. We are so pleased to have saved over $80.00 compared with hired labor 3 yre. ago for the same part. Thanks so much for your good service.

It was a piece of cake to replace them. Wish I had done it sooner with correct bowls, had purchased replacements from hardware store which were poor quality. :(

Made my range look brand new. I originally had generic drip pans that rusted and look terrible. Hopefully these OEM ones last longer. Now the burners are level because they slot into the drip pan. Just pull the burners out with your hands and replace the pans. Very east.

I raised the cook top up, and blocked it. I then removed the metal switch cover beneath the bank of switches and I replaced the switch which took about 15-30 minutes. The problem was cured.

I did as the video suggested.....I cut the old wires and spliced new ones already attached to the new terminal block. It would have been nice to have some instructions with the parts as I expected one piece but had to connect the wires to the new block and the new metal cover. I was guessing a bit. Also, I needed to use the holder strip off my old part so that it displaced the new part back far enough to insert the burner connections. That meant finding a screw and nut small enough to allow the metal cover to fit on the block. But the burner works great. I've learned that any repair requires some ingenuity.

the original path was from the right front control knob around the back of the range and left side of range,which i dismantaled to install the new wires to the right front burner. When I found them to be to short I had to also dismantal the right side so the wires could be routed there. The new wires worked fine but did take some extra time.