86902 (Type 8) Porter Cable Router - Parts

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This replacement switch is a high-quality component which is supplied by the original equipment manufacturer for use with Porter Cable routers. It is the part of the tool handling on/off operations, over time mechanical switches tend to wear out and may begin to fail eventually requiring replacement. Please note this durable plastic body power switch is sold individually.

This genuine OEM sourced item is specially made for use with Porter Cable routers. The purpose of this cover is to secure and protect the internal components. It provides an identical replacement for a missing or a faulty motor housing cap that was installed on a new unit, please make sure to refer to the appropriate diagrams of your mode...Read morel for the correct location and application of this part. This high-quality cap is made of durable plastic and is sold individually, keep in mind the hardware to secure it is sold separately.

This is an Authentic Manufacturer Approved replacement part used on Routers. This part provides a firm grip for holding a bit in a tool. It is made out of Metal and is Sold Individually. This Collet is for using bits with 1/2" arbors only. Includes the 1/2" Collet and a Collet Nut. Due to prolonged, heavy use a Collet may need to be repl...Read moreaced eventually. To replace this Collet you would need to use a Wrench. • First you would need to remove the Collet Nut • Once the Nut is removed you can remove the old Collet • Place a new one in place • Tighten the Collet Nut back in place and your unit is ready to use 1/2" Bits

This is a Genuine Manufacturer Approved replacement part used on some Routers. This part provides the firm grip for holding a bit in a tool. This Collet is for using bits with 1/4" arbors. Due to prolonged, heavy use a collet may need to be replaced. Collet Nut is included in this Assembly.

This item has been sourced from the original manufacturer and is intended to be used with routers from Porter Cable and Black & Decker. The fan attaches to the motor's armature assembly. This item is used to move air over the motor to prevent the motor from overloading. This item is sold as an individual replacement part.

This is a genuine Porter Cable replacement part, it is sold individually. A Cord Strain Reliever is used on most all power tools. It purpose is to reduce the bending of the cord as it comes out of the housing, which otherwise would cause the cord to crack and wear.