7MMVWC200DW2 - Instructions

Removed the fabric softner dispenser, used a 7/16 socket with ratchet to remove the bolt, pulled up on the Lower Agitator. Placed on floor, put foot on each side pulled up on the Upper Agitator tossed away. Cleaned the lower agitator at top reached in with a pair pliers removed the two little tits. Replaced the parts as per instructions with parts. Wished they had included the grease as part of the kit, i just used some white grease it reples water and good for friction. My kit did not have a new bolt in it.

Easy, If your drive block has an open top, it's worn. Look at a picture of a new drive block and compare. If it doesn't match, then you need a new drive block. Note: Also check the drive clutch and clutch liners or pads...they may be worn. In my case it was the drive block this time. So to start, take off the fabric softenner dispenser in the center of the washer. Then pull out the seal. then remove the bolt. and pull off the agitator assembly. after that tap off the lock nut with a punch and hammer or if you have the special spanner wrench tool, use that. Once removed, pull out the inner tub and then pull the drive block off the shaft. Put the new drive block on and reverse the procedure from there. Tap the lock nut tight with the punch and hammer while re-installing. I'm so glad I did this repair. $15 is so much better than just giving in and buying a new washer!!!

I watched a Part Select video on replacing the augitator and just followed the directions to replace the thrust washer (which was showing wear) and the washer. The instructions that came with the thrust washer were helpful as well.