7MMPM0060VM0 Maytag Washer - Parts

Also known as an O-Ring. This black o-ring seal is three inches in diameter.

The O-Ring is included with this cap. It can be purchased separately as Part #WPW10072840.

This main outer tub seal is a critical component that prevents water from leaking at the bottom of the tub during operation. Measuring approximately 2 inches in diameter, it is constructed from durable black plastic for long-lasting performance. Proper installation requires disconnecting power, drain hose, and inlet hose, followed by remo...Read moreving the outer cabinet and the entire tub assembly. Inspect the seal for cracks or wear during maintenance to avoid leaks and ensure optimal washer performance.

Sold Individually.

This spring is used on the leveling components in a washer. Please note, this spring may differ in appearance, but functions the same as original.

Use this dispenser for your direct drive washing machine.

This part goes on the agitator retaining bolt.

This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring ret...Read moreainer. You will find the suspension spring retainer at the bottom of the tub assembly. To replace the retainer, use a pair of pliers to disconnect the suspension spring from the chassis mount to relieve the tension. Then, remove the spring from the retaining clip, and remove the retaining clip from the bottom of the washer. Attach the new retaining clip to the bottom of the washer, reattach the spring, and stretch it slightly so it can connect to the chassis. This part is sold individually.

This is a pack of three suspension pads for your washer. The suspension pads in your washer are found underneath the tub and prevent the rotating metal parts from grinding on one another. If your suspension pads are worn out, you will likely hear metal-on-metal grinding, which is an indication they need to be replaced. It is recommended to replace all three suspension pads at the same time.

This drain hose is 42" long and includes the clamps.

This is used in your direct drive washer that has a neutral drain.