7MBPL9764PQ0 Whirlpool Washer - Parts

Used to drain water.

This nut is sold individually. Size: 3/8-16

Sold individually.

This spin tube T-Bearing is an inch long. Sold individually.

This gray and white washer lid bumper contains a rubber bottom and is sold individually.

This two piece oil seal kit comes in two pieces and is used for the gearcase input shaft of your washer.

Note: This part has been updated by the manufacturer. It may appear different but will still function the same as the original.

Sold individually.

This basket drive assembly is for washers. Basket drive assembly sits on top of the transmission shaft and houses the spin basket brake mechanism. The basket drive spins to rotate the basket during the spin cycle.

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside the switch. More water that enters the tub, more pressure is applied against the switch.

This clamp helps to prevent leaking by holding the end of water hose in place.

If your washer is noisy or shaking, the spanner nut might need replacing. This part locks the inner tub to the drive block so it spins smoothly during cycles. It has a right-hand thread and is easy to install with basic tools—just make sure the washer is unplugged and water is turned off before you start. A simple fix for a quieter, more efficient wash.