71603 (ASTCSE3) LG Refrigerator - Parts

If your fridge doors aren’t sealing properly or you’re noticing cold air escaping, this front plate assembly might be the fix. Also called a mullion or flipper, it fits between the French doors to keep the cold in and your food fresh. Made for select LG and Kenmore models, it’s built from sturdy plastic and helps your fridge run more efficiently. Just check your model number to make sure it’s the right fit.

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighten the screw. If your screw is missing or broken, it may need to be replaced. There are multiple handle screws on your fridge, please consider ordering extra as ...Read morethey commonly wear at the same rate. This is about 1 inch long and metallic in color.

Sold individually.

This deli drawer is for refrigerators. Deli drawer holds meats, vegetables and snacks in the fresh food compartment of the refrigerator. Follow the instructions in the owner's manual when installing this part.

This door gasket is used to make an air-tight seal for the cabinet when the door is closed

This 13-volt evaporator fan motor helps circulate air over the refrigerator coils. These coils will then convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. If the fresh food section is too warm or the motor has failed, you will need to replace the evaporator fan motor. It is sugges...Read moreted to replace the thermistor when replacing the evaporator fan. The fan motor is in the freezer section of the refrigerator, and includes the harness and plug. Please remember to disconnect the power to the refrigerator before starting your repair. This is a genuine OEM part.

If your French-door fridge isn’t sealing like it used to, this mullion spring could be the fix. It helps the flap between the doors close smoothly and stay in place, keeping cold air in and frost out. A faulty spring can lead to gaps, temperature issues, or ice buildup. This clockwise spring is easy to install—just remember to unplug your fridge first for safety.

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is damaged, your refrigerator door may not open and shut properly, and therefore it should be replaced.

The compressor overload protector attaches to the compressor and shuts off the compressor if the compressor motor draws too much current.