All Installation Instructions for Whirlpool Refrigerator 6WSC20C6XY02

No problem

This was a brand new refrigerator. My wife wanted an additional bin for the fridge door. Thanks for having this and shipping promptly.

Parts Used:

Refrigerator Door Bin

WILLIAM from Wichita Falls, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

water filter missing

alone

Parts Used:

Refrigerator Ice and Water Filter

stefania from miami beach, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

one of the fan blades was broke causing it to vibrate

removed the back cover unplugged the unit removed the old fan blades installed the new easy to pull off and easy to install

Parts Used:

Fan Blade

michael from westminster, SC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

Was this instruction helpful to you?

No Repairs Required, Added One Bin-Cntlur

Slide into position.

Parts Used:

BIN-DOOR, RC, SHALLOW

Philip from Pleasanton, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

cracked filter housing

two screws out, two screws in. piece a cake! Don't ever store the fridge, for even a brief time in freezing temps. The temps will expand and bust every part still holding water!

Parts Used:

Housing

Don from Saint Joseph, MO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

Broken rear wheel

I unplugged the unit Frist. Then I removed the grill covering the compressor and fan from the back. I then located the rear wheel and pin. I bent down the retaining tab and removed the pin and wheel. I installed new wheel and pin and bent retaining tab back to origional location. Replaced grill and checked unit for proper operation.

Parts Used:

Cab Roller

daryl from Palm Harbor, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

broken fan blade

unplug refrigerator, take backing off with nut driver. Pull old blade off and put new blade on. Put backing back on and plug in.

Parts Used:

Fan Blade

David from Ceres, CA
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

Was this instruction helpful to you?

Broken rear support wheel

remove fiber grill cover, remove large bolt holding under frame ( with a 2X4 block, place under refrigerator on outside edge so frame can drop down.) remove pin from broken wheel, replace reversing proceedure. Note: when blocking refrigerator, care must be taken not to let block extend under entire frame. it only needs to be placed approx 3/4" under edge of refrigerator.

Parts Used:

Cab Roller

Adam from Freeland, MI
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Socket set

Was this instruction helpful to you?

Coupler between ice tray and chute broken.

Followed your expert instructions, no problem. Less than 20 minutes.

Parts Used:

Refrigerator Ice Bin Coupling

Leonard from Philadelphia, PA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Both light bulbs had been replaced, but lights did not turn on.

I tried to remove the old light switch using a putty knife and a hammer. It was hard to compress the plastic tabs to pull it back through the hole, but all of a sudden, the lights came on. I guess banging on the switch freed-up the contacts. The new switch is now a spare part in case I need it.

Parts Used:

Refrigerator Door Switch

Richard from Arlington, MA
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

light would come on and off

Viewed the viedo - it showed what to do

Parts Used:

Refrigerator Door Switch

Dora from Rock Island, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Ice maker would not disperse cubes through the door

Looked at drawing to see what sequence the parts went.

Parts Used:

SPRING

Danny from Fulton, MO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

Was this instruction helpful to you?

Refrigerator needed neplacement water filter

Opened holder removed old filter and replaced with new filter

Parts Used:

Refrigerator Ice and Water Filter

Wayne from Studio City, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Ice not coming out when pressing level outside freezer door.

Remove ice storage container from inside freezer. Remove philips screw from the coupler underneath ice storage container. Removed coupler and flat washer. Installed new plastic coupling and metal flat washers. Relaced original coupler and screw. Tighten screws very carefully. Installed ice storage container and filled it with fresh ice. Ice is now coming out when the level on the outside of the freezer door is pressed. Yeah...

Parts Used: