6WSC20C6XB02 Whirlpool Refrigerator - Instructions

Simply removed screw, replaced coupling and screwed back into place. Took less than a minute. Good as new!

Removed the screw at the base of the ice bin unit. Replaced the coupling that had broken teeth and screwed in the new one. Was very simple. With service call with part near $150 the repair was made for less than $20.

I unscrewed the screw holing the coupling in place.Made sure the washers whereput back in right and put the new coupling in and retightened the screw on the auger that holds the coupling in place and then put the ice bin back in place and away it went.

The old coupling was no longer in the unit so I took out the set screw inserted the new coupling and reset the screw and now my ice maker works again like a champ. Less than 10 minute repair but took an extrea 5 as I had to mnake a new washer that goes under the coupling for wear resistance.

Popped the old one out with a kitchen knife and popped the new one back in. It tool less than 15 seconds!!

My owners manual said to unplug fridge from elec outlet, use a kitchen knife to gently pry off the switch plate
(manual had a pictoral example), unclip the two wire, replace with on new switch and replace the switch. Close
door and plug back in. Open door to check that the lite
works. Walla! It did. Thanks!

Sincerely, Ron Marshall, Billings, MT

I removed the ice bin to clean out the ice when I noticed the broken part under the bin. I went to my local parts supplier and was told I had to replace the entire bin and assembly for about $185. I found your web site and recieved the part the next morning for $17 including shipping. It was repaired in 5 minutes. Thank you Parts Select.

removed old part and screw from bottom of ice bin, installed new part with screw & back in business.

Installed the new ice bin coupling

I pried the old one out with a screw driver and pushed the new one in. I expected instructions in the box it came in but there were none.

i pulled out the ice bin and empty it and check the bottom of the bin and the ice bin coupling broken so i ordered the coupling from parts select,and it only took me 30 minute to put it back its working as new now

Carefully followed the unit’s manual instructions

I installed a Ice Door Kit. It works Great Now!

shook bottle and painted waited a day and repeated

Please bear in mind I am 65 years old & it was harder to get up & down off the floor then to change the switch. Was very easy - watched video, unplugged unit. I used the putty knife at the right front corner to work loose, when it came loose had to loose the left side a little. The unit pulled out easily. detached the wired that had a single plug with 2 prongs on it. Attached the plug, pushed new switch into place. There was no way you could place wires on wrong prong. When done, plugged refrigerator back in & checked if working. I CAN SEE THE LIGHT and the food in the freezer now. Thank you for making an easy repair.