6824NA Makita Electric Drill - Parts

Included in Part Number 516306-1. rnThis Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls re...Read moreduces friction. This reduces wear on the tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This is an authentic Makita replacement part manufactured for use with power tools and a brushless string trimmer. The o-ring is commonly used to form a seal at the front end of a motor assembly to prevent dust or debris from entering the motor housing. This o-ring is a versatile part, and the usage of the o-ring vary depending on the model of the tool. This o-ring is sold individually.

This is a genuine Makita replacement part, it is sold individually. It is part of the bit holder. Without this Ball the bit would not stay in the holder. It is used in a number of different tools for different reasons. But it is most popular in Cordless Impact Drivers and Corded Screw Drivers. Compatible with the tools listed below. The diameter is 3.5mm.

This genuine manufacturer-approved part which is specially designed for use with Makita screwdrivers. It is an identical replacement for a missing or faulty leaf spring that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware. Ke...Read moreep in mind this high-quality item is made of durable metal and is sold individually.

It is a genuine OEM sourced replacement part, this component is specially produced for use with Makita screwdrivers. The purpose of this spring is to apply tension on the collared pin, unfortunately, over time it may wear out, get damaged or simply lost eventually requiring a replacement. Keep in mind this high-quality hardware is made of...Read more durable metal and is sold individually. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this compression spring.

This cord protector is an OEM part designed for a variety of Makita power tools. It is attached where the power cord meets the tool. This part protects the cord from damage due to pulling, bending, or other strain. This rubber cord protector is sold individually. It does not include a replacement cord.

This is an authentic Makita manufactured for use with electric power tools. The special strain relief is commonly used to secure the power cord wires to the switch block to prevent the wires from being pulled out of the switch. This strain relief is available as an individual replacement part, please see model diagram for associative parts.

This is an authentic replacement part manufactured for use with Makita power tools. The special label is a great item to improve the look of the tool and can rejuvenate a refurbished tool. This label is available as an individual replacement part, please see model diagram for associative parts.

This authentic component is specially designed for use with Makita power tools. It is an identical replacement for a faulty or a missing hardware that was installed on a new unit. Refer to the owners manual and the appropriate diagrams of your model for the correct installation and application of this part. When using the hook, pull it ou...Read moret in "A" direction and then push it in "B" direction to secure in place. When not using the hook, return it back to its initial position by following the above procedures in reverse. This high-quality plastic hook is sold individually.