6702 (Type 1) Porter Cable Router - Parts

This replacement brush holder is an authentic OEM sourced item, not an aftermarket imitation. It is specially designed for use with electric power tools. This item is used to secure the carbon brush. This brush holder is made out of metal and plastic and it is sold individually. Please note, the carbon brush and the cap are both sold sepa...Read morerately. Replacing this assembly does not require any tools. • First make sure the tool is unplugged • Remove the brush cap • Remove the carbon brush • Remove the old brush holder • Install the new brush holder • Reassemble and test the tool

This is an original part from Porter Cable. The metal pin is compatible with many router and saw devices, and is sold individually. This item is often used to as a guide to secure the casing. Please refer to manual for safety and repair instructions.

This part is supplied by the original equipment manufacturer for use with Porter Cable, DeWALT and Black and Decker power tools. The ring is generally utilized to secure a component on a shaft. It is a standard hardware which will have multiple applications, make sure to check the diagrams of your model for the exact location. Keep in min...Read mored this high-quality part is made of durable metal and is sold individually. It is recommended to use snap-ring pliers to secure or remove this hardware.

This is an authentic OEM sourced replacement 1/2 inch collet. It is specially designed for use with Black and Decker and Porter Cable routers. This part allows user to secure bits with 1/2 inch arbors only. It is made out of metal and is sold individually. Please note the collet nut is sold separately. To replace this item you will need a wrench.

It is a genuine item which is made for use with Porter Cable power tool. This part is supplied directly from the original equipment manufacturer. It is a special component which helps to connect two lead wires. The part is utilized to connect the on/off switch to the tool. It is a simple plastic item which is sold individually. Replacing ...Read moreit will only require a screwdriver, take apart the housing, remove the old part and secure the wires using the new connector.

A tool that cuts out when its cord is moved may have a damaged power cord. Before replacing it, inspect the plug, outlet, extension cord, switch, motor brushes, and connections inside the tool. Confirm fit with the complete tool model because the wire ends and strain relief may differ. Unplug the tool and wait for it to stop fully. Mark e...Read moreach wire before disconnecting it, and never bypass the ground wire. Follow the original cord path, tighten the clamp, close the housing, and have the tool tested for electrical safety before use.

Restore your power tool’s performance with this genuine Porter-Cable replacement carbon brush. This OEM part is not generic—it’s designed specifically for the compatible models listed in the 'Compatibility' section below. The brush comes ready to install and includes the carbon brush, wire lead, and spring. Sold individually (note: most t...Read moreools require two), it’s an essential component for maintaining motor efficiency. Carbon brushes are wear items, meaning they gradually degrade through friction and use. Worn brushes are a common cause of poor motor performance, intermittent operation, and reduced electric braking. A worn brush may appear cracked, pitted, burned, or worn down near the wire lead. Replacing them can restore your tool’s power and reliability. When installing new brushes, it’s also recommended to inspect the armature for signs of damage such as burns or cracks, which may indicate deeper motor issues.

This authentic item is supplied directly from the original equipment manufacturer for use with routers made by Porter Cable. The bit is available as an individual replacement part. During replacement, it may require a set of pliers to help install this part correctly. It is made of metal and will need to be replaced if it breaks.