66561614101 Kenmore Microwave - Instructions

Removed the broken parts and screws and placed the new vent on and tightened screws. I am an 76 year old woman, so if I could do this, then anyone can! Surprisingly easy to install.

Removed the screws holding the broken tabs and thought the new vent grille would click right into place. I had quite a bit of trouble getting all the tabs lined up to click into place, but was finally able to do it. Then I just used the old screws to secure the new grille.

Glass plate arrived in less than two days. Placed the glass plate in Microwave and presto the microwave works like a charm.

submitted manufacturer info to website and voila! a new glass turntable arrived in 2 days. I don't do well with computers, my 23 yr. old daughter was impressed......couldn't be easier! thanx! will definitely revisit your site

Removed screws holding tabs from broken vent grill to microwave frame.

Carefully snapped new grill vent into slots on top of microwave and slid tabs into slots on top of the frame.

Replaced the two screws in the tabs.

Finished

All I had to do was open the microwave door and place the turntable on the designated grooves, wha lah it fit. I am now back in business. Thanks to partselect, I found my replacement, ordered and it was shipped in no time.

took old vent grill and tabs off using phillip screwdriver. started putting new grill on and it wouldnt go on. got to looking and there are two more screws that you have to loosen up so the grill will go into place these two screws are between the two tabs at each end. caution do not over tighten the screws it will break the tabs. overall easy to install.

Take out the screws, broken pieces of clip, then put in the new vent grill, replace the screws. Done!

I removed the broken tabs with a screwdriver and snaped in the new cover replacing the screws once I had it in place. the entire job took less than 5 min.

put the turntable in and had a Rum and Coke to celebrate. Your service was GREATTTTTT...

I remove the old broken Grill Vent by loosing two screws and just put the new one and adjusted with the same two screws.

I simply removed the original 2 screws for the old grill, attached the new grill, fastened it with the original screws & It fit perfectly in less than 5 minutes time.

First, I ordered the part.The part was sent to me within 2 days.Then,I removed the old one that was always falling off and mounted the new one. It was a perfect fit.

I have been doing repair on things on my own for years, I am a retired prevenative maintenace supervisor.
While cleaning the microwave vent grill from being old it fell apart, so I ordered the part using the internet to find the a company that has the same part, the part didnt take long before I recieved it. It didnt take five minutes to install it, and it saved me cash in the pocket from someone else to do the work. wallen

I, carefully, inserted the bottom tabs into the appropriate slots. I then rotated the vent piece up and into place under the top lip of the Microwave. Once positioned I installed the screws required to hold the piece in place. Very simple replacement. It gave me a chance to clean the grease behind the vent.