All Installation Instructions for Kenmore Trash Compactor 66513614101

I changed the front panels from the original beige to stainless steel

The repair was a breeze, a piece of cake, a walk in the park, a day at the beach. The part arrived quickly and installation was fast and simple. A week earlier I had the misfortune of ordering these parts from another supplier. One of the parts obviously was not correct, so I called customer service. Although the operator was polite, she insisted that the part I received was the right one (even though it was 2 inches too narrow). I looked up the part at PartSelect.com and ordered it. It arrived the following day, and fit perfectly. Thanks, PartSelect.com.

Parts Used:

Guard

Walter from San Rafael, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Broken drive gears

Took out old gears replaced with new very easy with your dirictions.

Parts Used:

Drive Gear Kit

THOMAS from DENNISPORT, MA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers, Wrench set

Was this instruction helpful to you?

Large plastic gear cracked in half. Compactor was stuck in the compact postition

replaced the large gear and put it back together.

Parts Used:

Drive Gear Kit

Mike from Campbell, CA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set

Was this instruction helpful to you?

plastic gear broke in half

Same problem as described previously on this site. Pulled unit out and replaced the gear as described. Thanks for the info - would have been tough with out it.

Parts Used:

Drive Gear Kit

Richard from WAYLAND, MI
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins

Was this instruction helpful to you?

Broken plastic drive gear

Very simple, changed the gear, adjusted the drive and tested. Very straight forward.

Parts Used:

Drive Gear Kit

Charles from Goshen, KY
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set

Was this instruction helpful to you?

compactor will not stop when compaction complete on top cycle

take 2 screws out on top cover with key switch. remove two screw holding directional switch. remove wires, one at a time, and place on the new switch. put new switch in place with two screws. put front cover on with two screws and test. works like a charm.

Parts Used: