66513499K600 Kenmore Dishwasher - Parts

The rack track stop on your dishwasher is designed to stop the dish rack at the appropriate place when opening and closing the rack. If your dishwasher is not cleaning your dishes properly, the rack stop may need to be replaced. The replacement part may differ slightly from the broken part, depending on the model. However, the different s...Read moretyles are interchangeable. This product is sold individually and comes in both a white and grey plastic version. Many of our customers found this repair to be very easy and takes less than 30 minutes to complete. Simply snap the old part out and snap the new part into place. You will not require any tools to complete the job. This is an authentic part approved by the manufacturer.

This part is used with the lower spray arm.

This part will fit between the newer type lower wash arm and the wash arm retainer nut of your dishwasher.

This white under spray arm bearing ring is designed with the split. This is not a defective or damaged item.

Sold Individually.

This dishwasher drain and wash impeller kit comes with both the drain and wash impeller, gaskets, chopper and installation screw. This part helps stop your dishwasher from leaking and helps with the proper draining of the dishwasher.

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

If your dishwasher is leaking during use you may need to replace the gasket. The door gasket wraps around the sides and top of the dishwasher door and provides a waterproof seal between the tub and the door. It is gray in color and made of rubber. Once you have installed the door gasket it is recommend to close the dishwasher door and lea...Read moreve it closed for a few hours to make sure the door gasket properly seals. This is a genuine OEM part.

This metallic spring is for your dishwasher's soap cup cover. Sold individually.

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of water needed. NOTE: As per the manufacture this part has been updated from the original part. It may be a different color, and you may need to order an elbow (# W10685193) for the new designed valve to work.

*Please Note - When changing the fuse always use a new wiring harness.

This cap does not require the use of a o-ring seal.