66513042K115 Kenmore Dishwasher - Parts

This part has been redesigned and now comes in a kit. This kit includes 2 adjuster assemblies, 1 left-hand and 1 right-hand actuator cover, 2 gray adjuster covers, and 2 gray adjuster housings.

Sold individually. This part secures the upper side of the dishwasher to the underside of the counter or cabinet to prevent the dishwasher from moving, shaking, or tilting forward.

This is a lower spray arm for a dishwasher. The lower spray arm allows water to be spread evenly throughout the dishwasher tub with the proper force so dishes come out clean. This spray arm is gray in color and is about 20 inches long. You may need to replace this part if the water is not being distributed.

This manufacturer-certified heating element is used to create heat during the dry cycle and increase water temperature during portions of the wash cycle when certain options are selected. If your dishes are not drying or the water in the dishwasher is not getting hot you may need to replace the element. This kit includes the heater, two h...Read moreeater fasteners, and is a genuine OEM part. Please remember to disconnect the power before starting the repair. Use a multi-meter to test your heating element for continuity to determine whether this is the part that is causing your symptom. This part does not include any washers. To make your repair, disconnect the wires from the bottom of the element in the back, remove the plastic nuts holding it in place, remove the element, and repeat these steps in reverse order to install your new part. This is an easy repair that requires only a screwdriver, wrench set, and should take less than 30 minutes.

This manufacturer-approved Rack Stop Clip is a gray plastic part which can be installed with a screwdriver. Measuring slightly over an inch in length, it prevents the rack from sliding too far and falling off. If broken or damaged, then the rack will slide too far and this is a sign the part should be replaced. It attaches to the end of t...Read morehe top dishwasher rack. This clip can be used for the left or right side, and is sold individually. It is a good idea to replace both sides at once. To make this repair, start by pulling out the rack, then, using your screwdriver, reach in behind the rack stops and press the clips in. You should be able to remove the stops from the track from here. Next, you should be able to slide the track back over the rollers and snap the new track stop into place.

This drain pump is used in dishwashers to remove water from the dishwasher tub. If the impeller in the dishwasher is damaged or the motor has been shorted out and will not drain, it is possible the body is cracked, causing leakage. To prevent this from happening, replace the drain pump. The tools needed for this installation are: Phillips...Read more screwdriver, 5/16 inch nut driver, 5/8 inch wrench, and a flathead screwdriver. Remember to unplug your dishwasher from the power source before beginning this installation project. Refer to the manual provided by the manufacturer for further installation instructions.

Also known as rack adjuster. Sold individually. This is an original part from KitchenAid, Kenmore, Whirlpool, Jenn-Air, and Maytag for use with Dishwashers. The dishrack adjuster arm positioner clip holds the adjuster arm in the right position on the dishrack. The most common reason for replacing the strap is if the rack will not stay i...Read moren its desired position. This part is sold individually. There are no tools needed to replace the positioner.

This part helps to keep your door quiet when it opens and closes.

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

This part attaches to the lower dishrack.

Struggling with a dishwasher that's not cleaning your dishes properly? The issue might lie with your spray arm, a crucial part of your Whirlpool dishwasher's functionality. This top-quality Whirlpool spray arm is here to solve your dishwashing woes by boosting the performance of your appliance. When your spray arm is functioning its bes...Read moret, it rotates and sprays water evenly and powerfully across your dishes. This ensures an in-depth, comprehensive cleaning for each and every item in the dishwasher tub. The result? Dishes that sparkle, every time. Our Whirlpool spray arm is built to last, giving your dishwasher the endurance to tackle countless cycles of dirty dishes. With its durable construction, you can count on a lasting performance that stands up to regular, everyday use. Do note, it's best to wear work gloves while handling this part during repair, simply ensuring your hands are safe while you get your dishwasher back to top condition. Choose this Whirlpool spray arm and reignite the power of your dishwasher. With every wash, you'll appreciate the unmatched cleanliness standard it provides. After all, your Whirlpool dishwasher should be as relentless in cleanliness as you are. Invest in peace of mind and sparkling dishes today.

This dishrack adjuster allows you to change the height of the top rack in your dishwasher, making room for larger items below or optimizing space for smaller loads. If the clip becomes damaged or worn, the rack may not stay in place and could shift during cycles. Replacing the adjuster restores proper rack positioning and smooth operation...Read more. This part is sold individually, so be sure to order the correct quantity for your dishwasher model.