5KSM175PSEAC5 KitchenAid Mixer - Parts

This worm gear is an inch and a half in diameter. It is used for some of Whirlpool's brands of mixers.

This wire whip is for stand mixers. Wire whip attaches to the beater shaft and incorporates air into cream, eggs and frostings. Follow the instructions in the owner's manual for using and installing this part.

Used for Kitchenaid Mixers.

This Flat Beater Part Number WPW10672617 is for Stand Mixers. Attaches to the beater shaft and is for normal to heavy mixtures such as cake batters or cookie dough. This has a powder coated finish.

This metallic retaining ring is less than an inch in diameter. It is made entirely of metal.

This small metal pin locks the center gear to its shaft inside a stand mixer. Replace it if the pin is bent, broken, or missing. A damaged pin may let the motor run while the beater stays still. This is an internal gear pin, not the large hinge pin that joins the mixer head to the base. Use the full mixer model number to guarantee the proper fit. Unplug the mixer before opening the gear housing.

Used in Mixers.

This part is used with the stand mixers attachments, as well as to hold the end cap to the front of the mixer.

This is a powder coated dough hook used on stand mixers.

Use with stand mixers.

The speed control lever on your stand mixer allows you to adjust the speed that the mixer is running at. The lever is approximately 3.5 inches long, with a black plastic handle at the top. The speed control lever connects to the interior of your stand mixer, so you will have to take it apart to access the bar that the lever is attached to...Read more. Once you’ve opened the mixer, you can unscrew the old lever, taking care not to misplace the screw or washer that holds it in place. Replace the old lever with the new one, and then put the mixer back together.

Sold individually.