All Installation Instructions for Kenmore Refrigerator 59672002011

The right door gasket was cracked in two or more places and probably leaked.

I watched the Part Select demonstration for removing and replacing the door gasket. It looked easy and was easier and faster than the demo. The toughest part was getting the wrinkles out of the new door seal.

Parts Used:

Refrigerator Door Gasket - White

JAMES from BREVARD, NC
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Ice was not ejecting - motor was dead

Followed some online videos. The replacement part actually matched exactly what the videos I found showed. It was my refrigerator that was slightly different where the unit would mount/screw into. The old unit had a bracket which easily attached to the replacement part. It is less than a 1 hour repair for sure. But it took me a few minutes to figure out the bracket adapter. Plus I forgot to seat the ice maker shut off bar and had to disassemble some things again to get in there to seat it properly. Part was shipped quickly and securely !

Parts Used:

Refrigerator Ice Maker Assembly

David from PITTSBORO, NC
Difficulty Level:
Really Easy
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Ice maker quit working

Unplugged wire plug, removed mounting screws and removed ice maker. Installed new unit by reversing steps--

Parts Used:

Refrigerator Ice Maker Assembly

Lloyd from Algona, IA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

My refrigerator vegetable bins were sagging when I placed veggies in it.

I came across this site and looked at the diagrams. Instead of buying a new crisper bin frame, I noticed that the crisper bin frame was missing the frame brace. I purchased the frame brace and installed it in the crisper frame, which was easy to push into the slot. This solved my problem. No more sag!!

Parts Used:

Refrigerator Crisper Frame Brace

Lee from SAMMAMISH, WA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Right Door Magnet weak, door would not stay firmly closed

Replaced seal on door. Same problem. Went to Lowe's and got several magnetic cabinet door catches. Attached them to the top of the door. (they can be seen sticking up), with the magnet part screwed to the door and the metal plate attached to a small wooden block glued to the top of the body with contact cement. Cost abound $16.

"To infinity and beyond."

Parts Used:

Refrigerator Door Gasket

Larry from CHIRENO, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Old gasket was worn out

Heated new gasket in dryer. Removed old gasket. Took less than five minutes per door and I am 78 years old!

Parts Used:

Refrigerator Door Gasket

Peggy from WOODSTOCK, GA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Easy fix for Whirlpool refrigerator

I followed the video provided by Part Select. I also let the refrigerator stay unplugged overnight with all the doors open. This p-trap kit has fixed the leaks out of the front of the refrigerator. There is no ice build-up in the freezer. Perfect!

Parts Used:

P-Trap Drain Tube Kit

John from MABLETON, GA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

freezer (later fridge too) wouldn't stay cold~

****Make are you order Capacitor & Starter relay too (we ordered separtely so had to pay shipping twice)**** Super easy just open access panel on back near compressor and remove retention clip with fingers, remove & replace both capacitor & starter, put clip and access panel back on, plug in and allow 8 hours to cool! Works like new again! Hope it goes another 10 years

Parts Used:

Refrigerator Capacitor

David from MARYLAND HTS, MO
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

The refrigerator was clicking but not turning the compressor on long enough to work. So the freezer was thawing and freezing which froze the drain line completely. Forcing the water to flood the refrigerator.

I unplugged the capacitor which allowed access to the on/off relay. Unplugged the old broken one and plugged in the new one. All better.

Parts Used:

Compressor Overload and Start Relay

Robert from Pleasant Mount, PA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Pliers

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

the rail broke from overloading the drawers

got the new part, took the old part out and snapped the new part in! Very easy. Thank you.

Parts Used:

Refrigerator Center Crisper Drawer Slide Rail - White

Joan from SILVERDALE, WA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Ice Maker Not operationl

Have part need instructions to remove old and install new

Parts Used:

Refrigerator Ice Maker Assembly

Kenneth from LAGUNA HILLS, CA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

3 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Clean the glass and asked my wife to install the glass. She is less likely to brake the glass

Removed the plastic frame, washed the frame and fridge, set new glass into the frame.

Parts Used:

Refrigerator Crisper Glass

Dan from WATERVILLE, MN
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

drip pan was cracked

Removed rear cover, removed fan and than drip tray. install new tray and reassemblied

Parts Used:

Drip Pan

Brian from Bismarck, ND
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver

28 of 82 people found this instruction helpful.

Was this instruction helpful to you?

The refrigerator was working for just 1 minute and breaks, I discovered that the fan was not working , I understood that there wsa something wrong with the condenser fan motor. I just order a new one.

The installation video for condenser fan motor helped a lot to know how to disconnect the old fan motor and connect the new one. So easy just know how to remove and put back the fan gently, observe carefully where is the center and the connector position; 15 min after everything was done and the unit works well to date.

Parts Used: