5860 - Parts

Genuine manufacturer supplied replacement brush set designed for use with Craftsman worm drive saws. Due to constant contact with an armature brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type. This assembly includes two (2) carbon brushes with lead wires and springs atta...Read moreched. Please note brush caps are sold separately. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • Remove the brush cap and take out the old brush • Secure the new brush with a cap and test the saw

• This cord guard is a genuine Skil replacement part and is sold individually. • Cord guards, also called cord protectors, are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard. • T...Read morehis cord guard will fit cords for the tools listed under the "Compatible Tools" listing. It is not guaranteed to fit any other cords.

This power cord is a three-wire cord and connection terminals are already installed. This cord also includes a metal locking tab for a secure attachment to your tool.

This is an authentic Briggs & Stratton replacement part. The fuel tank cap is designed by the manufacturer for use in engines such as those found in tillers, lawn tractors, and blower-vacuums. This part is made of metal, and is used to cover the refill nozzle of the fuel tank. No tools are required when replacing this item. Simply rem...Read moreove the old part and screw the new one into place. This item is sold individually.

This is sold as a set that contains three rings. The rings attach to the piston and help to create a seal. When replacing these parts a screwdriver, a set of pliers, and a socket set might all be required during the installation process. These parts are made out of metal and will need to be replaced if they break or bend. They are authent...Read moreic Briggs & Stratton and Toro replacement parts that are sourced from the original manufacturer for use with engines, generators, tillers, and blower-vacuums.

This is a genuine Toro replacement part. The ring set is designed by the manufacturer for use in engines such as those found in generators, tillers, blower-vacuums, and lawn mowers. This part is a set of three metal rings, which are inserted into grooves on the outer surface of the piston to help seal it in the cylinder. You may require a wrench and pliers when replacing these items.

This authentic manufacturer rewind starter spring is a replacement part used in various power equipment engines. It is connected to a pulley system, and it is found inside the starter housing. It is a tightly wound metal spring that stores and releases energy to pull the starter rope back into the housing after starting the engine. If you...Read more are having difficulties starting the engine, or pulling and retracting the starter rope, then the rewind starter spring may be broken or worn down, and in need of replacement. It is recommended to replace the rope at the same time if it is frayed or worn down. Begin this repair by switching off the equipment for your safety. Disassemble the starter housing, and slowly unwind and remove the old spring. Position the new spring in the housing and tension it properly. Reassemble the housing to complete the repair.