56231B0WW General Electric Washer - Parts

This is a replacement hub washer for your washing machine. If your washer is noisy, leaking, shaking, or pumping without spinning, you may need to replace the hub washer. The hub washer is found under the washer tub, beneath the split ring. You will need to remove the tub to access it. Before doing so you should disconnect the power and w...Read moreater sources from washer. The washer is made of metal and is a little more than an inch in diameter. It is sold individually, and is an OEM part.

This part is the replacement inner tub base hub for your washer. It is made of metal and is approximately 15 inches in diameter. The inner tub base hub fits between the wash tub and the spin basket, and it holds the spin basket on the gear case shaft. The main reason you would want to replace the hub, is if the washer will not agitate, or...Read more if you notice excessive noise or shaking when the washer is in use. Be sure to disconnect the washer from the water and power sources before you begin this repair. This part is sold individually and is and OEM part from the manufacturer.

This clip holds the drain hose to the back of the washer.

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

This part is a replacement fabric softener dispenser for your washer. If your washer will not dispense fabric softener or detergent, or will not agitate, you may need to replace the dispenser. When it is working, the dispenser releases fabric softener during the wash cycle. You can find the dispenser screwed in to the top of the agitator...Read more. To replace the dispenser simply unscrew it, and replace it with a new one. This is an OEM part, and is sold individually.

This is a water pressure switch hose, also known as the air dome tube, for your washer. It is made of clear plastic and is sold individually. The hose transports water to your water pressure switch, so the switch can control how much water enters the washer during a cycle. If your washer will not fill up with water, or if water continues ...Read moreto fill the tub even after it is full, you may have a damaged water pressure switch hose. Inspect the hose for cracks and leaks, and if the hose is damaged you will need to replace it.

Used in conjunction with the timer dial knob assembly.

Also known as a Rotary Switch. This part regulates the temperature of the water in the tub.

This replacement inlet drain hose connects your washer's water pump to its tub. This hose is seven and a half inches in length and only two inches wide.

This part is a replacement socket rod support for your washer. The socket rod support is found at the top of the washer frame in the front part of the washer. It supports the suspension rod, so the rod can prevent the tub from shaking too much during operation. If your washer is shaking excessively or emitting an odd sound during use, it ...Read moremay be because the rod support is broken, and the suspension rod is not able to do its job. This part is made of white plastic and is sold individually.

This knob and clip assembly is a manufacturer-approved replacement part for your dryer. This timer knob sets the correct time on your dryer. If the shaft becomes damaged, the timer may no longer work. Replacing it is an easy procedure and requires no tools. Pull off the existing timer knob, and slide the new one onto the shaft, making sure to line up the shaft with the knob correctly.