52750-5 General Electric Washer - Parts

The upper drum felt glide kit helps to support the front drum as it rotates smoothly and quietly while operating. This kit includes three glides with the adhesive. If your dryer won’t tumble or is noisy, the glide could be worn down causing you to hear a metal on metal noise and will need to be replaced. The drum glide is a genuine OEM pa...Read morert and sold individually. Please remember to disconnect the power to the dryer before starting your repair.

This Drive Belt is 89.5" long and comes in black, featuring four ribs on the inside for a better grip. This is a long belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley, allowing all the parts to work together, spinning the drum as the motor rotates. If the drum will not turn...Read more when the dryer is turned on the belt is likely broken. It is common for belts to stretch or become brittle over time, which is what leads to the breakage. If broken, it should be replaced; the drum simply cannot spin without this belt. Refer to your model number and user manual to check if this part is right for you. Ensure you use work gloves to protect your hands from sharp internal parts during this repair. Please note: When comparing the length of your old belt to the length of the belt as stated here, remember that a small amount of stretching and contortion may occur with belts over time for a range of different reasons. Unless your belt is drastically different in length, this belt is what you are looking for despite any small inaccuracies. You will need to remove power to your appliance, remove the main panel, and access the motor drive to slip your new belt back into place.

This knob accepts a D-shaped shaft.

"Male" piece of a dryer door closing mechanism.

This part comes with a ninety degree elbow.

This dryer heating assembly has 5/16" terminal on the housing.

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

This idler pulley assembly is a manufacturer-approved replacement part for your washer/dryer. The assembly includes the idler pulley and arm. The idler pulley provides tension for the belt to rotate the drum. You may notice your idler pulley making a sqeaking or squealing noise, signalling that it needs to be replaced.

This idler arm assembly comes with the pulley wheel.

This water level switch is designed to accurately monitor and regulate the water level in select washing machine models. Engineered for reliable performance it helps ensure efficient operation by maintaining the correct water volume during each cycle. Before installation it's important to disconnect the appliance from power and turn off t...Read morehe water supply for safety. Wearing work gloves is recommended to protect your hands during the process. As part sizes and shapes may vary slightly please confirm compatibility with your washer model before purchasing.