41793802201 Kenmore Washer Dryer Combo - Parts

"Male" piece of a dryer door closing mechanism.

This high limit thermostat has a limit of 260 degrees Fahrenheit. Meaning that it will cut out when the internal dryer temperature reaches 260. This thermostat cuts back in when the temperature drops by 70 degrees Fahrenheit.

This knob accepts a D-shaped shaft.

This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.

This seal helps prevent any leaking around the transmission of washing machines.

Sold individually.

This drum bearing bracket is for dryers. Drum bearing bracket holds and supports the drum bearing

This dryer heating assembly has 5/16" terminal on the housing.

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).

This agitator helps your washer clean clothes better by moving them around during the wash cycle. It spins back and forth to mix water and detergent evenly, loosening dirt and keeping clothes from getting tangled. If your laundry isn’t coming out as clean or you’re seeing twisted items, replacing the agitator could be the fix. It’s a simple way to get your washer working like new again.

This blower wheel is a genuine OEM replacement part for your dryer. The wheel can become damaged through use of the dryer, especially if the drive motor shaft, which it is attached to, becomes damaged. This repair will require some disassembly of the dryer. Make sure to disconnect the power source and wear appropriate work gloves while conducting this repair.