41791702001 Kenmore Washer Dryer Combo - Parts

This start switch is a manufacturer-approved replacement part for your dryer. A faulty start switch means your dryer will not begin its drying cycle. In order to complete this repair, you will need a Phillips screwdriver. Once you access the switch, disconnect the two wire leads and attach them to the new switch. Make sure to disconnect power to the unit before beginning this repair, and wear work gloves.

"Male" piece of a dryer door closing mechanism.

This high limit thermostat has a limit of 260 degrees Fahrenheit. Meaning that it will cut out when the internal dryer temperature reaches 260. This thermostat cuts back in when the temperature drops by 70 degrees Fahrenheit.

This knob accepts a D-shaped shaft.

This is a replacement screw for your washer or dryer. The screw is approximately half an inch in length and is a Phillips-head screw. It screws in from the outside of the drum, into the vane/baffle. The main reason you would replace this screw is if the old screw is missing or damaged. This part is sold individually and is an OEM part sourced directly from the manufacturer.

This seal helps prevent any leaking around the transmission of washing machines.

Sold individually.

This drum bearing bracket is for dryers. Drum bearing bracket holds and supports the drum bearing

This dryer heating assembly has 5/16" terminal on the housing.

Mounting bracket on this part replaces old style ( You may need to drill off old bracket before mounting new lock).